STM32W108B-SK STMicroelectronics, STM32W108B-SK Datasheet - Page 19

• Manufacturer Part Number: STM32W108B-SK
• Description: STARTER KIT FOR STM32W108
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: MCUr

Specifications of STM32W108B-SK

• Featured Product: STM32 Cortex-M3 Companion Products
• Contents: Board
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32W108xx
• Kit Contents: Board
• Features: IEEE
• Mfg Application Notes: STM32W108 Adjacent Channel Rejection Measurements
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: *
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

UM0894
3.3
Note:
3.4
IAR Embedded Workbench® for ARM
To install the IAR Embedded Workbench® for ARM 5.40.7 or later, insert the related CD-
ROM and follow the installation instructions.
To build the binary image of all the available demonstration applications using the IAR tool,
follow these steps:
1.
2.
3.
To download the built binary image on the MB851 board, follow these steps:
1.
2.
3.
4.
To use the J-Link Lite JTAG Flash programmer, you need to switch on the "power supply for
target" feature. The first time you plug the J-Link Lite on a PC USB port, follow these steps
(make sure that you have already installed the IAR Embedded Workbench 5.40.7 or later):
1.
2.
3.
Reflashing STM32-Primer2 using prebuilt primer2image.hex
file
The primer2image.hex file contains the three CircleOs applications described in
This file is delivered with the installed package in the prebuilt folder. To download a new
version of the primer2image.hex file or just recover from an accidental deletion, follow these
steps:
1.
2.
3.
4.
5.
6.
Open the IAR tool.
From the File > Open > Workspace menu, open the *.eww IAR project related to the
demonstration application you are going to address.
From the Project menu, select Rebuild All. A binary file is built under the project folder
specified in Project > Options > General Options Category > Output menu >
Executables/libraries item.
Connect the JTAG Flash programmer to the MB851 P4 connector and to a PC USB
port (through an USB cable).
Power the MB851 application board through the JTAG: P2 jumper fitted on 5-6 position.
From the Project menu, select Download and Debug. The binary image is downloaded
into the STM32W108xx Flash.
From the Project menu, select Stop Debugging. The application is ready to run.
Open an DOS Window on your PC.
Type jlink.
Issue the command: power on perm.
Install Raisonance Ride 7.16 (or later) for ARM if not already installed on your PC (this
toolset is available on www.stm32circle.com).
Go to the prebuilt folder.
Connect a mini USB cable to the STM32-Primer2 debug connector and a PC USB port.
Turn on the STM32-Primer2 by pushing its button.
Type the command: Cortex_pgm TSTM32F103VET6 E B.
Type the command: Cortex_pgm TSTM32F103VET6 Pprimer2image.hex S.
Doc ID 16999 Rev 2
STM32W108xx kits utilities and software tools
Chapter
19/21
2.