LAN9215-MT SMSC, LAN9215-MT Datasheet - Page 131

• Manufacturer Part Number: LAN9215-MT
• Description: CONTROLLER, ENET, NON-PCI, 100TQFP
• Manufacturer: SMSC

Specifications of LAN9215-MT

• Data Rate: 100Mbps
• No. Of Ports: 2
• Ethernet Type: IEEE 802.3 / 802.3u
• Supply Current: 40mA
• Supply Voltage Range: 2.97V To 3.63V
• Operating Temperature Range: 0°C To +70°C
• Digital Ic Case Style: TQFP
• Interface Type: HBI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Highly Efficient 10/100 Ethernet Controller with HP Auto-MDIX
Chapter 7 Operational Characteristics
SMSC LAN9215
7.1
7.2
10BASE-T Operation
D0, 10BASE-T /w traffic
D0, Idle
D1, 10BASE-T /w traffic
D1, Idle
D2, Energy Detect Power Down
D2, General Power Down
100BASE-TX Operation
D0, 100BASE-TX /w traffic
D0, Idle
* Stresses exceeding those listed above could cause permanent damage to the device. This is a stress
Supply Voltage ................................................................................................................... +3.3V +/- 10%
Operating Temperature ..........................................................................................................0°C to 70°C
Storage Temperature.........................................................................................................-65°C to 150°C
Positive Voltage on any pin, with respect to Ground ........................................................................ 5.5V
Negative Voltage on any pin, with respect to Ground ..................................................................... -0.3V
Note: The maximum pin ratings do not apply to the following analog pins - ATEST, RBIAS, EXRES1,
rating only and functional operation of the device at any other condition above those indicated in the
operation sections of this specification is not implied.
Note: When powering this device from laboratory or system power supplies, it is important that the
Note: The power measurements list below were taken for previous generation LAN9118 Family
Temperature: .................................................................................................................................. +25° C
Device VDD:..................................................................................................................................+3.30 V
Absolute Maximum Ratings*
Power Consumption Device Only
TPO +/-, TPI +/-
absolute maximum ratings not be exceeded or device failure can result. Some power supplies
exhibit voltage spikes on their outputs when AC power is switched on or off. In addition, voltage
transients on the AC power line may appear on the DC output. If this possibility exists, it is
suggested that a clamp circuit be used.
devices, and have not yet been confirmed for the LAN9215. They should be used only as
estimates. These measurements were taken under the following conditions:
Table 7.1 Power Consumption Device Only
MODE
DATASHEET
131
TOTAL POWER - TYPICAL (MW)
Revision 1.2 (03-29-06)
244
225
120
120
422
367
35
11