C500CN122N Omron, C500CN122N Datasheet - Page 56
C500CN122N
Manufacturer Part Number
C500CN122N
Description
I/O CONNECTION CABLE
Manufacturer
Omron
Datasheet
1.C500-AP003.pdf
(140 pages)
Specifications of C500CN122N
Leaded Process Compatible
No
Peak Reflow Compatible (260 C)
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
- Current page: 56 of 140
- Download datasheet (2Mb)
I/O Connections
4-2
Terminal Block
I/O Connections
Note Putting I/O Lines and high-tension lines or power lines in the same duct or con-
Note When a Triac Output Unit is used to drive a low-current load, the load may not
Connect the I/O Devices to the I/O Units using AWG (cross-sectional area:
0.3 mm
tional area: 0.3 to 0.75 mm
screws with 3.5-mm diameter heads and self-raising pressure plates. Connect
the lead wires to the terminals as shown. Tighten the screws to a torque of 0.8
NSm.
Use ring crimp terminals for wiring. Do not connect bare stranded wires directly
to terminal blocks.
The terminal block of an I/O Unit can be removed by loosening the mounting
screws. You do not have to remove the lead wires from the terminal block in or-
der to remove it from an I/O Unit.
duit may cause the I/O Lines to be affected by noise. This may cause a malfunc-
tion in the I/O Unit or may cause damage to the I/O Unit or I/O devices.
turn completely OFF due to a leakage current. To compensate for the leakage
current, connect a bleeder resistor in parallel with the load.
7 mm max.
2
) for 19-terminal terminal blocks and AWG 22 to lead wire (cross-sec-
Terminal block mounting screws
Loosen the terminal block mounting screws to remove
the terminal block from the I/O Unit. Make sure the
mounting screws on the terminal block are tightened af-
ter wiring is complete, and the terminal block is re-
mounted to the I/O Unit.
2
) for 10-terminal terminal blocks. The terminals have
7 mm max.
Section 4-2
43
Related parts for C500CN122N
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
PROGRAMMING CONSOLE ADAPTER
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
TEACH BOX I/F CBL FOR NC
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: