CV500-MC221 Omron, CV500-MC221 Datasheet - Page 24

• Manufacturer Part Number: CV500-MC221
• Description: SERVO CONTROL MODULE
• Manufacturer: Omron

Specifications of CV500-MC221

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4-1
Caution Do not duplicate Unit No. settings. Duplication may result in damage to both the Servo Driver
Note 1. For multiple axis communication set a Unit No. from 1 through to E (14) inclusive.
Note 2. H/L and UE have no Unit No. setting for multiple axis communication (multiple axis commu-
1. Turning On
2. Access a Directory
Pre-start Check Criteria for On Line Mode
Start Procedure







When using multiple axis communications set each Servo Driver’s Unit No. before connecting to
the IBM PC/AT or compatible.
Securely connect the IBM PC/AT or compatible to the Servo Driver using the Connecting Cable
listed in 1-2 System Configuration .
Once connected to the Servo Driver, turn the Servo Driver on.
Turn the IBM PC/AT or compatible on.
A DOS prompt such as
If the Menu Program starts, exit the program and return to DOS.
Type the following to access the Computer Monitor Software directory.
The prompt
Following Chapter 2 Installation , this chapter describes how to start and quit the Com-
puter Monitor Software installed on an IBM PC/AT or compatible.
The Computer Monitor Software has two modes.
Before starting in on line mode, carry out a pre-start check.
Start Procedure
nication cannot be performed).
For HA/LA set the Unit No. using a Parameter Unit.
For UT set the Unit No. using the rotary switch on the front panel.
and IBM PC/AT or compatible when the Servo Driver communicates with the IBM PC/AT or
compatible.

 
On line mode: The Servo Driver is connected to carry out parameter settings
and monitor control.
Off line editing mode: The Servo Driver is disconnected for parameter edit and
graph display.

 
will appear.


should appear.
Chapter 4