UPL1-1-72-103 AIRPAX, UPL1-1-72-103 Datasheet - Page 20

• Manufacturer Part Number: UPL1-1-72-103
• Description: CIRCUIT PROTECTOR, HYD-MAG, 1P, 250V 10A
• Manufacturer: AIRPAX
• Series: UPLr

Specifications of UPL1-1-72-103

• Input Voltage Vac: 250V
• No. Of Poles: 1
• Current Rating: 10A
• Interrupting Capacity: 5kA
• Dielectric Strength: 1.5kV
• Trip Time: 20s
• Voltage Rating Vdc: 65V
• Leaded Process Compatible: Yes
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

186
APL/UPL DECISION TABLES
How to Order
The ordering code for APL/UPL circuit protectors may be
determined by following the steps in the decision tables shown
here.
The coding given permits a self-assigning part number; other
configurations may require a factory assigned part number.
Typical examples are units with mixed ratings, combinations of
styles or constructions not listed in the third decision table, etc.
With these, it is suggested that order entry be by description
and/or drawings and a part number will be assigned. Additionally,
it is a standard policy to establish a factory assigned part number
wherever a descriptive drawing exists to provide cross
reference, traceability and manufacturing control.
When specifying a protector for AC motor start or high inrush
applications, the peak amplitude and surge duration should be
specified for factory assistance in rating selection.
For example, the code shown is the code for a two pole UPL
protector with series trip, 20 ampere rating, 50/60Hz. short time
delay construction in all poles.
To determine the ordering number for your particular APL/UPL
unit, simply follow the steps shown. You may use this number to
place an order or as a reference for further questions you may
have.
APL/UPL, 205/295 - APL/UPL Decision Tables
Notes:
A The most common current values for 100% of rated current are
B All APL/UPL protectors are constructed with stainless steel
C Terminals will be supplied as #10-32 threaded studs up to 50
D When metric threaded inserts are specified, breakers rated at
E Black handle standard.
those listed. Please consult an Airpax office orsales representa-
tive for other values.
springs and plated parts. As noted in the specifications, all meet
normal requirements for moisture and salt spray resistance. If
fungus resistance is required in addition to moisture and salt
spray resistance, special procedures and markings are employed.
amperes. Above this amperage terminals will be ¼ -28 threaded
studs. All standard units will be supplied with a hex nut and two
flat washers on each threaded terminal.
50 amperes and below will be supplied with metric threaded
terminals. For breakers rated above 50 amperes, ¼ -28 threaded
terminals will be supplied.
http://airpax.sensata.com/