17 22 095 2102 HARTING, 17 22 095 2102 Datasheet - Page 12

• Manufacturer Part Number: 17 22 095 2102
• Description: PCB CONNECTOR
• Manufacturer: HARTING

Specifications of 17 22 095 2102

• Connector Type: HARD METRIC (HM)
• Gender: PIN
• No. Of Contacts: 95
• Pitch Spacing: 2MM SERIES
• Contact Plating: GOLD
• No Of Rows 5: LEADED PROCESS COMPATIBLE

00 .
10
Contact assignment on CompactPCI
position (J1/P1)
In mechanical terms J1/P1 is a 25x5 matrix of
contacts. Three rows of 5 contacts (rows 12 - 14)
are not used for electrical contacts. Instead, plastic
keys of different orientation and configuration
are used to key board locations as to system or
peripheral slot, voltage options, etc.
J2/P2 is a shortened connector with only 22 rows
of contacts instead of 25 rows for a standard size.
HARTING now offers monolithic versions with J1/P1
and J2/P2 combined in one single connector.
This combination together with some space left on
the card to fit into guide rails makes maximum use
of the 100 mm rear edge of the 3U Eurocard.
On a 6U card this connector setup is repeated on
J4/P4 and J5/P5.
The J3/P3 connector is a shortened version of
the 2.0 mm connector with 19 rows of 5 signal
contacts.
The size results from the height of a 6U board
(233 mm) which is more than double the height of
a 3U board.
CompactPCI
®
system
®
– general information
Contact assignment on CompactPCI
position (J2/P2)
All connectors used for CompactPCI
on a 7 column pitch. The inner 5 columns are used
for logic signals and power. The outer columns on
either side are reserved for shielding or ground.
Executive Member
®
are based
®
system