ASDL-3007-021 Avago Technologies US Inc., ASDL-3007-021 Datasheet - Page 3

• Manufacturer Part Number: ASDL-3007-021
• Description: Infrared Transceivers SIR+RC transceiver
• Manufacturer: Avago Technologies US Inc.

Specifications of ASDL-3007-021

• Wavelength: 885 nm, 875 nm
• Continual Data Transmission: 115.2 Kbit/s
• Transmission Distance: 50 cm
• Radiant Intensity: 19 mW/sr
• Half Intensity Angle Degrees: 30 deg to 60 deg
• Pulse Width: 4 us, 1.6 us
• Maximum Rise Time: 60 ns, 600 ns
• Maximum Fall Time: 60 ns, 600 ns
• Led Supply Voltage: 5.5 V
• Maximum Forward Current: 32 mA
• Operating Voltage: 2.4 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 25 C
• Dimensions: 7 mm x 2.8 mm x 1.6 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Application Support Information
The Application Engineering Group is available to assist
you with the application design associated with ASDL-
3007 infrared transceiver module. You can contact them
through your local sales representatives for additional
details.
Order Information
I/O Pins Configuration Table
Notes:
1. Tied through external resistor, R1, to Vled. Refer to the table below for recommended series resistor value.
2. Complete shutdown of IC and PIN diode. The pin is used for setting receiver bandwidth and RC drive
3. This pin is used to transmit serial data when SD pin is low. If held high for longer than 50 ms, the LED is turned
4. This pin is capable of driving a standard CMOS or TTL load. No external pull-up or pull-down resistor is
5. Regulated, 2.4V to 3.6V
6. Logic high turns on the RC LED. If held high longer than 50 ms, the RC LED is turned off. Do NOT float the pin.
7. NC.
8. Connect to system ground.

Part Number
ASDL-007-021
Pin
1
2

4
5
6
7
8
programming mode. Refer to section on “Bandwidth Selection Timing” and “Remote Control Drive Modes” for
more information. Do NOT float this pin.
off. Do NOT float this pin.
required. The pin is in tri-state when the transceiver is in shutdown mode.
CAUTIONS: The CMOS inherent to the design of this component increases the component’s susceptibility
to damage from electrostatic discharge (ESD). It is advised that normal static precautions be taken in handling
and assembly of this component to prevent damage and/or degradation which may be induced by ESD
Symbol
LEDA
SD
TxD_IR
RxD
Vcc
TxD_RC
NC
GND
Packaging Type
Tape and Reel
Description
LED Anode
Shutdown
IrDA transmitter data input.
IrDA receive data
Supply Voltage
RC transmitter data input.
Ground
Package
Front Option
Quantity
2500
I/O Type
Input. Active High
Input. Active High
Output. Active Low
Input. Active High
Marking Information
The unit is marked with ‘PYWWLL’ on the back of the PCB
for front option without shield.
P = Product Code
Y = Year
WW = Work Week
LL = Lot Number
Notes
Note 1
Note 2
Note 
Note 4
Note 5
Note 6
Note 7
Note 8