IP4064CX8/LF /T3 NXP Semiconductors, IP4064CX8/LF /T3 Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
IP4064CX8/LF /T3
Manufacturer Part Number
IP4064CX8/LF /T3
Description
Multimedia Misc INTEGRATED ESD
Manufacturer
NXP Semiconductors
Type
Integrated SIM Card Passive Filter Arrayr
Specifications of IP4064CX8/LF /T3
Mounting Style
Surface Mount
Termination
Flat Style
Product Height (mm)
0.7mm
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 30 C
Package / Case
WLCSP
Lead Free Status / RoHS Status
Compliant
Other names
IP4064CX8/LF,135
NXP Semiconductors
IP4064CX8_IP4364CX8_IP4366CX8_2
Product data sheet
9.3.1 Stand off
9.3.2 Quality of solder joint
9.3.3 Rework
For further information on temperature profiles, refer to application note AN10365
“Surface mount reflow soldering description”.
The stand off between the substrate and the chip is determined by:
The higher the stand off, the better the stresses are released due to TEC (Thermal
Expansion Coefficient) differences between substrate and chip.
A flip-chip joint is considered to be a good joint when the entire solder land has been
wetted by the solder from the bump. The surface of the joint should be smooth and the
shape symmetrical. The soldered joints on a chip should be uniform. Voids in the bumps
after reflow can occur during the reflow process in bumps with high ratio of bump diameter
to bump height, i.e. low bumps with large diameter. No failures have been found to be
related to these voids. Solder joint inspection after reflow can be done with X-ray to
monitor defects such as bridging, open circuits and voids.
In general, rework is not recommended. By rework we mean the process of removing the
chip from the substrate and replacing it with a new chip. If a chip is removed from the
substrate, most solder balls of the chip will be damaged. In that case it is recommended
not to re-use the chip again.
Fig 9.
•
•
•
The amount of printed solder on the substrate
The size of the solder land on the substrate
The bump height on the chip
temperature
Temperature profiles for large and small components
MSL: Moisture Sensitivity Level
IP4064CX8; IP4364CX8; IP4366CX8
All information provided in this document is subject to legal disclaimers.
Rev. 02 — 11 February 2010
= minimum soldering temperature
Integrated SIM card passive filter array with ESD protection
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
temperature
peak
© NXP B.V. 2010. All rights reserved.
001aac844
time
10 of 14