0638191100 Molex Inc, 0638191100 Datasheet - Page 4

• Manufacturer Part Number: 0638191100
• Manufacturer: Molex Inc
• Type: Hand Crimp Toolr

Specifications of 0638191100

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool For .093” & .125” Pin and Socket and Commoning Crimp Terminals
Doc No: ATS-638191100
Revision: A
2. Make sure the center of the locator is in the down position. With the locator attached, push the locator button
3. While holding in the locator button, load the terminal into the proper
4. Release the locator button, allowing the locator to return to the crimping
5. Close the tool handle until the first ratchet position engages. See
6. Insert the properly stripped wire through the terminal and against the
7. Crimp the terminal by squeezing the tool handles until the ratchet
Note: The tamper proof ratchet action will not release the tool until it has been fully closed.
Figure 2
on the back of the hand tool to bring the locator forward through the tooling. See Figure 2.
nest opening in the locator, based on the wire gauge or terminal type
markings on the hand tooling. See Figure 3.
position.
Figure 4.
wire stop. See Figure 5.
mechanism cycle has been completed. Release the handles to open
the jaws.
PRE-STRIPPED
LOCATOR BUTTON
TERMINAL
WIRE
PUSH ON THE
DOWN POSTION
LOCATOR IN
Release Date: 01-09-08
Revision Date: 01-09-08
PUSHED THRU
LOCATOR
TOOLING
TERMINAL
WIRE AGAINST
Figure 5
THE WIRE
STOP
UNCONTROLLED COPY
WIRE
PUSHED IN
LOCATOR
BUTTON
Figure 3
TERMINAL
POSITION
OPEN
FIRST RATCHET
CLOSE HANDLE
POSITION
PARTIALLY
TERMINAL
WIRE STOP IS
PART OF THE
LOCATOR
PARTIALLY
TOOLING
CLOSED
Figure 4
Page 4 of 9
LOCATOR
RELEASE
BUTTON