NT31C-ST143-EV3 Omron, NT31C-ST143-EV3 Datasheet - Page 174

• Manufacturer Part Number: NT31C-ST143-EV3
• Description: 5.7 8-Color Dsp,STN,Ivory,Eng
• Manufacturer: Omron

Specifications of NT31C-ST143-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Precautions to Be
Observed When
Transmitting Screen Data
Transmitting the Screen Data
4. Open the screen data to be transmitted at the Support Tool, then select
5. During screen data transmission, the transmission status is displayed.
6. On completion of screen data transmission, press the Quit touch switch.
If the screen data cannot be successfully transmitted from the Support Tool,
use the communications check functions of the NT31/NT31C to check if com-
munications between the NT31/NT31C is normal or not (page 214).
If any of the following, or a system error, occurs during transmission of screen
data, the transmitted screen data will not be registered correctly in the NT31/
NT31C. If this happens, the NT31/NT31C may not enter the RUN mode when
started up, or there may be unpredictable malfunctions such as failure to dis-
play screens during operation. In this case, the screen data must be retrans-
mitted in file units to register it correctly.
• The power to the NT31/NT31C is interrupted or the NT31/NT31C is reset.
• The power to the personal computer on which the Support Tool is running
• The cable connecting the NT31/NT31C to the personal computer on
• The Quit touch switch on the NT31/NT31C screen is pressed to end
• Screen data transmission is stopped by operation at the Support Tool.
Download (NTST PT) in the Support Tool’s Connect menu and specify the
data to be transmitted.
The NT31/NT31C returns to the Transmit mode.
is interrupted or the computer is reset.
which the Support Tool is running is disconnected or has a broken wire.
screen data transmission.
Ver 4.12
Select Transmit Mode.
Select Tool Transmit.
Section 6-6
157