NT31C-ST143-EV3 Omron, NT31C-ST143-EV3 Datasheet - Page 60

• Manufacturer Part Number: NT31C-ST143-EV3
• Description: 5.7 8-Color Dsp,STN,Ivory,Eng
• Manufacturer: Omron

Specifications of NT31C-ST143-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Errors When Using a
Memory Unit
System Program in the PT
and Memory Unit for Each
PT Mod
Using a Memory Unit
4. Press Execute.
5. Switch the NT31/NT31C power OFF, remove the Memory Unit, then switch
If an error occurs when using the Memory Unit, the NT31/NT31C operates as
follows.
If a protect setting error occurs when executing manual transmission, it is pos-
sible to return to the Memory Unit manual transmission screen by pressing
the OK touch switch, but in the case of other errors, the status described
above remains in effect until the NT31/NT31C power is turned OFF or reset.
The system program for each model of PT is given in the following table.
When an error occurs, take remedial action by referring to the table below.
Mode setting error
Protect setting error
(automatic transmis-
sion)
Protect setting error
(manual transmis-
sion)
• When writing the system program into the NT31/NT31C, the type of sys-
• The details of the error and remedial action are displayed on the screen.
• The continuous buzzer sounds.
• The RUN LED flashes.
NT31
NT31C
NT31-V3
NT31C-V3
tem program inside Memory Unit and the type of PT must correspond.
The data is transmitted.
The messages Preparing, Transmitting, Verifying, and Finished are dis-
played in accordance with the progress of data transmission. At the same
time, the progress of data transmitting status is displayed by the means of
the number of bytes and blocks (1 bank = 16 block = 1024k byte).
When the data transmission is operated manually, RUN LED remains OFF.
the NT31/NT31C power back ON.
Each screen has touch switches to change the display language from one
to the other. When the manual data transmission is operating, the content
of error and remedial action are shown with selected language. When the
automatic transmission is operating, it is displayed in Japanese.
Error
System program for NT31/NT31C PT models without a -V suffix,
and for NT31/NT31C PT models with a -V1 and -V2 suffix
System program for NT31 PT models with a -V3 suffix
DIP switches SW1-1 to
SW1-3 are all OFF, or
more than one is ON.
Writing to the data write
destination has been pro-
hibited by the setting of
SW2-1 or SW2-2.
Writing to the data write
destination has been pro-
hibited by the setting of
SW2-1 or SW2-2.
Probable Cause
Turn the NT31/NT31C power OFF,
set the Memory Unit DIP switches
correctly, then turn the NT31/
NT31C power back ON.
Turn the NT31/NT31C power OFF,
set the Memory Unit DIP switches
correctly, then turn the NT31/
NT31C power back ON.
Perform either of the following pro-
cedures.
• Press the OK touch switch to
• Turn the NT31/NT31C power
return to the Memory Unit manual
transmission screen, make the
correct settings, then try again.
OFF, correct the DIP switches set-
tings of the Memory Unit, then
turn the power back ON.
Remedial Action
Section 3-5
43