E5-648-C4462 EATON CUTLER HAMMER, E5-648-C4462 Datasheet - Page 4

• Manufacturer Part Number: E5-648-C4462
• Description: PRESET COUNTER, 6-DIGIT, 10VDC TO 30VDC
• Manufacturer: EATON CUTLER HAMMER

Specifications of E5-648-C4462

• No. Of Digits / Alpha: 6
• Digit Height: 9mm
• Supply Voltage Range: 10VDC To 30VDC
• Power Consumption: 90W
• Counting Speed: 50kHz
• Operating Temperature Range: -20°C To +65°C

Instruction leaflet IL05407001E
Effective October 2010
4. Display/operating elements
Key
T1-6
P
R
8
9
10
11
12
Pr
5. inputs
5.1 INP A, INP B
•
•
•
•
•
5.2 Reset
•
•
•
•
5.3 Gate
•
•
•
•
4
Signal inputs: function according to operating mode
Max. frequency 55 kHz, can be damped in the programming
menu to 30 Hz
Pulse counter: count inputs
Frequency meter: frequency inputs
Timer: start input or start/stop inputs
Dynamic reset input: resets the pulse counter or timer to
zero (adding mode) or to preset value 2 (subtracting mode).
The reset input can be inhibited in the programming menu
Pulse counter: RESET input
Frequency meter: no function
Timer: RESET input
Static gate input: function depending on operating mode
Pulse counter: no counting while active
Frequency meter: no counting while active
Timer: no time measurement while active (Gate.hi);
no time measurement while not active (Gate.Lo)
Function
Decade key T1–T6
Prog/Mode key
Reset key
Current count value/main counter
Preset value/Total count/Batch counter
Run display for timer
Shows which preset value is being displayed
Shows which preset output is active
Keys necessary for programming the parameters (highlighted in grey)
eaton corporation www.eaton.com
5.4 Lock input
•
5.5 MPI
•
6. outputs
6.1 Output 1 and output 3
Relay with potential-free make (NO) contact
6.2 Output 2 and output 4
Relay with potential-free changeover contact
6.3 Active outputs
An active output will be shown on the display as
or
For safety switching the relay outputs can be inverted,
i.e. the relay will be de-energized when the presets are reached.
To do this, the parameters Pr.OUT1 to Pr.OUT4 must be set to
(for permanent signal) or
7. programming
7.1 Entering the program
7.2 Choice of main menus
7.3 Entering a sub-menu
Static keypad lock input for presets or programming.
Lock-out level can be set in the programming menu
Input. Programmable as Display Latch, Set or Teach-In input
.
LCD negative, red-green backlighting
counter with four presets (relays)
The menus are selected using the
keys T2 (next) and T1 (back)
The sub-menu is opened with the
Prog/Mode key and the first menu item
is displayed
Press the Reset key and Prog/Mode key
simultaneously for 3s
The security prompt appears in the display
Programming can be exited again using
the Prog/Mode key
Press key T2 to continue with the
programming
The security prompt appears in the display
Enter the main menu by pressing
the Prog/Mode key
E5-648-C446x electronic preset
or
(for timed signal).
,
,