72-1015 TENMA, 72-1015 Datasheet - Page 23
![MULTIMETER, DIGITAL, BENCH, 3-3/4 DIGIT](/photos/27/66/276647/4720264_sml.jpg)
72-1015
Manufacturer Part Number
72-1015
Description
MULTIMETER, DIGITAL, BENCH, 3-3/4 DIGIT
Manufacturer
TENMA
Datasheet
1.72-1015.pdf
(56 pages)
Specifications of 72-1015
Dmm Type
Bench
Voltage Measuring Range Dc
600mV To 1000V
Voltage Measuring Range Ac
600mV To 1000V
Current Measuring Range Dc
60µA To 10A
Current Measuring Range Ac
60µA To 10A
Lead Free Status / RoHS Status
na
Model 72-1015: OPERATING MANUAL
Note
l
l
l
l
When measuring low resistances, the test leads and
internal wiring will add approximately 0.2
of error. To obtain accurate readings in low-resistance,
short-circuit the test lead beforehand and record the
reading obtained, call this reading as X. Then use
the equation:
measured resistance value (Y) – (X) = accurate
readings of resistance.
If
check for loose test leads or possible incorrect
function selection.
When measuring high resistance (>1M ), it is normal
to take several seconds to obtain a stable reading.
In order to obtain stable reading, choose shorter test
lead to carrying out measurement.
The LCD displays OL indicating open-circuit for the
tested resistor or the resistor value is higher than the
maximum range of the Meter.
reading with shorted test leads is not < 0.5 ,
~ 0.5
l
When resistance measurement has been completed,
disconnect the connection between the test leads and
the circuit under test, and remove the test leads from
the input terminals if the meter.
21