8145-1521-019 Aep (Applied Engineering Products), 8145-1521-019 Datasheet - Page 5

• Manufacturer Part Number: 8145-1521-019
• Description: Connector Accessories ST PCB Cable Termination Gold
• Manufacturer: Aep (Applied Engineering Products)
• Type: Cable Terminationr

—Trim cable per trim code below; tin end of center conductor.
—Slide backnut onto cable. Slide compression washer onto cable in
—Flare cable braid by rotating dielectric and slide ferrule under braid.
—Press ferrule against compression washer.
—Trim excess braid flush with outer diameter of compression washer
—Assemble insulator over cable center conductor and dielectric.
—Assemble contact onto cable center conductor.
—Solder contact to center conductor by heating rear of contact
—Insert cable assembly into body assembly. Tighten to 90–100
1
2
3
4
CONNECTOR TYPE
STRAIGHT CONNECTORS
RIGHT ANGLE CONNECTORS
Straight Connectors—Flexible Cable
the orientation shown until it stops against cable jacket.
and ferrule.
(do not feed additional solder through inspection hole in contact).
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
Cable Trim Dimensions
Note: for cable feedthroughs, trim dielectric and center conductor per application requirements.
Center conductor
Parts list
APPLIED ENGINEERING PRODUCTS
[phone] • FAX [phone]
Body assembly
Dielectric
Cable Assembly Instructions
Contact (male or female)
A
Insulator
Clamp type terminations for flexible cable
B
C
Ferrule
.080
.080
A
Braid
Compression washer
.120
.180
B
Backnut
Jacket
.240
.300
C
www.aepconnectors.com • [e-mail]
—Trim cable per trim code below; tin end of center conductor.
—Slide backnut onto cable. Slide compression washer onto cable in
—Flare cable braid by rotating dielectric and slide ferrule under braid.
—Insert cable assembly into body assembly. Tighten to 90–100
—Solder center conductor into notch in rear of contact with
—Solder should cover center conductor, but not extend over top of
—Place insulator in body cavity, and press cap into place.
Body assembly
1
2
—Press ferrule against compression washer.
—Trim excess braid flush with outer diameter of compression washer
—Assemble insulator over cable center conductor and dielectric.
3
4
the orientation shown until it stops against cable jacket.
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
.025–.032" diameter chisel-tip soldering iron.
notch in contact, or exceed contact diameter.
Right Angle Connectors—Flexible Cable
Properly assembled cap will be slightly below end of body assembly.
and ferrule.
Insulator
Solder
Cap
Parts list
Ferrule
Compression washer
Backnut
5