8145-1521-019 Aep (Applied Engineering Products), 8145-1521-019 Datasheet - Page 7

• Manufacturer Part Number: 8145-1521-019
• Description: Connector Accessories ST PCB Cable Termination Gold
• Manufacturer: Aep (Applied Engineering Products)
• Type: Cable Terminationr

—Trim cable per trim code below; tin end of center conductor.
—Slide backnut over cable. Slide solder ferrule over cable until it stops
—Solder cable jacket to ferrule.
—Assemble insulator and contact onto cable dielectric and
—Solder contact to center conductor by heating rear of contact
—Insert cable assembly into body assembly. Tighten to 90–100
1
2
3
Straight Connectors—Semi-Rigid Cable
against cable jacket.
center conductor. If insulator is not flush against solder ferrule due to
dielectric extrusion, retrim dielectric.
(do not feed additional solder through inspection hole in contact).
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
Cable Trim Dimensions
Note: for cable feedthroughs, trim dielectric and center conductor per application requirements.
Parts list
Center conductor
APPLIED ENGINEERING PRODUCTS
[phone] • FAX [phone]
Body assembly
Cable Assembly Instructions
Solder-clamp terminations for semi-rigid cable
Dielectric
A
Contact (male or female)
B
Solder
Insulator
Solder Ferrule
Jacket
Backnut
www.aepconnectors.com • [e-mail]
CONNECTOR TYPE
STRAIGHT CONNECTORS–.085" cable
STRAIGHT CONNECTORS–.141" cable
RIGHT ANGLE CONNECTORS
—Trim cable per trim code below; tin end of center conductor.
—Slide backnut over cable. Slide solder ferrule over cable until it
—Solder cable jacket to ferrule.
—Insert cable assembly into body assembly. Tighten to 90–100
—Solder center conductor into notch in rear of contact with
—Solder should cover center conductor, but not extend over top
—Place insulator in body cavity, and press cap into place.
1
2
3
Right Angle Connectors—Semi-Rigid Cable
stops against cable jacket.
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
.025–.032" diameter chisel-tip soldering iron.
of notch in contact, or exceed contact diameter.
Properly assembled cap will be slightly below end of body assembly.
Parts list
Body assembly
Insulator
Solder
Solder
Cap
Solder Ferrule
.090
.105
.110
Backnut
A
.170
.130
.150
7
B