8145-1521-019 Aep (Applied Engineering Products), 8145-1521-019 Datasheet - Page 6

• Manufacturer Part Number: 8145-1521-019
• Description: Connector Accessories ST PCB Cable Termination Gold
• Manufacturer: Aep (Applied Engineering Products)
• Type: Cable Terminationr

—Trim cable per trim code below; tin end of center conductor.
—Slide heat-shrink tubing and crimp sleeve over cable.
—Flare cable braid by rotating dielectric and slide cable into crimp tail.
—Position cable so braid touches rear of back nut.
—Slide crimp sleeve forward to touch rear of back nut.
—Crimp braid with appropriate die size from chart below.
—Assemble insulator and contact onto cable dielectric and
—Solder contact to center conductor by heating rear of contact
—Insert cable assembly into body assembly. Tighten to 90–100
—Slide shrink tubing over crimp sleeve and shrink to fit.
1
2
3
4
CONNECTOR TYPE
STRAIGHT CONNECTORS
RIGHT ANGLE CONNECTORS
Straight Connectors—Flexible Cable
center conductor.
(do not feed additional solder through inspection hole in contact).
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
Cable Trim Dimensions
Note: for cable feedthroughs, trim dielectric and center conductor per application requirements.
Center conductor
Parts list
APPLIED ENGINEERING PRODUCTS
[phone] • FAX [phone]
Body assembly
Dielectric
Cable Assembly Instructions
A
Contact (male or female)
Insulator
Backnut/crimp tail
Crimp type terminations for flexible cable
B
C
.100
.070
A
Braid
Heat-shrink tubing
(optional)
.430
.200
B
Crimp sleeve
Jacket
.700
.450
C
www.aepconnectors.com • [e-mail]
—Trim cable per trim code below; tin end of center conductor.
—Slide heat-shrink tubing and crimp sleeve over cable.
—Flare cable braid by rotating dielectric and slide cable into crimp tail.
—Position cable so braid touches rear of body assembly.
—Slide crimp sleeve forward to touch rear of body assembly.
—Crimp braid with appropriate die size from chart below.
—Solder center conductor into notch in rear of contact with
—Solder should cover center conductor, but not extend over top of
—Place insulator in body cavity, and press cap into place.
—Slide shrink tubing over crimp sleeve and shrink to fit.
1
2
3
4
Crimp Die Sizes
Right Angle Connectors—Flexible Cable
.025–.032" diameter chisel-tip soldering iron.
notch in contact, or exceed contact diameter.
Properly assembled cap will be slightly below end of body assembly.
Parts list
Body assembly
CABLE GROUP
Insulator
02
03
05
19
Solder
Cap
Heat-shrink tubing
(optional)
Crimp sleeve
HEX DIE SIZE
.105
.128
.128
.128
6