MJF15031G ON Semiconductor, MJF15031G Datasheet - Page 5

• Manufacturer Part Number: MJF15031G
• Description: TRANS POWER PNP 8A 150V TO220FP
• Manufacturer: ON Semiconductor

Specifications of MJF15031G

• Transistor Type: PNP
• Current - Collector (ic) (max): 8A
• Voltage - Collector Emitter Breakdown (max): 150V
• Vce Saturation (max) @ Ib, Ic: 500mV @ 100mA, 1A
• Current - Collector Cutoff (max): 10µA
• Dc Current Gain (hfe) (min) @ Ic, Vce: 20 @ 4A, 2V
• Power - Max: 2W
• Frequency - Transition: 30MHz
• Mounting Type: Through Hole
• Package / Case: TO-220-3 Full Pack (Straight Leads)
• Transistor Polarity: PNP
• Mounting Style: Through Hole
• Collector- Emitter Voltage Vceo Max: 150 V
• Emitter- Base Voltage Vebo: 5 V
• Maximum Dc Collector Current: 8 A
• Power Dissipation: 36 W
• Maximum Operating Temperature: + 150 C
• Continuous Collector Current: 8 A
• Dc Collector/base Gain Hfe Min: 40
• Maximum Operating Frequency: 30 MHz
• Minimum Operating Temperature: - 65 C
• Number Of Elements: 1
• Collector-emitter Voltage: 150V
• Collector-base Voltage: 150V
• Emitter-base Voltage: 5V
• Collector Current (dc) (max): 8A
• Dc Current Gain (min): 40
• Frequency (max): 30MHz
• Operating Temp Range: -65C to 150C
• Operating Temperature Classification: Military
• Mounting: Through Hole
• Pin Count: 3 +Tab
• Package Type: TO-220 Full-Pak
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: MJF15031GOS

** For more information about mounting power semiconductors see Application Note AN1040.
8 in
over time and during large temperature excursions.
plastic to crack around the mounting hole, resulting in a loss of isolation capability.
in order to positively ensure the package integrity of the fully isolated device, ON Semiconductor does not recommend exceeding 10 in
ing torque under any mounting conditions.
Laboratory tests on a limited number of samples indicate, when using the screw and compression washer mounting technique, a screw torque of 6 to
Destructive laboratory tests show that using a hex head 4−40 screw, without washers, and applying a torque in excess of 20 in
Additional tests on slotted 4−40 screws indicate that the screw slot fails between 15 to 20 in
.
lbs is sufficient to provide maximum power dissipation capability. The compression washer helps to maintain a constant pressure on the package
*Measurement made between leads and heatsink with all leads shorted together.
PLAIN WASHER
NUT
4-40 SCREW
HEATSINK
COMPRESSION WASHER
TEST CONDITIONS FOR ISOLATION TESTS*
Figure 12. Typical Mounting Techniques*
Figure 11. Mounting Position
MOUNTING INFORMATION
FULLY ISOLATED PACKAGE
http://onsemi.com
5
0.110, MIN
HEATSINK
LEADS
.
lbs without adversely affecting the package. However,
HEATSINK
CLIP
.
lbs will cause the
.
lbs of mount-