ICS1892Y IDT, Integrated Device Technology Inc, ICS1892Y Datasheet - Page 110

• Manufacturer Part Number: ICS1892Y
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of ICS1892Y

• Lead Free Status / RoHS Status: Not Compliant

ICS1892, Rev. D, 2/26/01
Table 9-6. MAC/Repeater Interface Pins: Media Independent Interface (MII) (Continued)
MDIO
RXCLK
RXD0,
RXD1,
RXD2,
RXD3
Name
Pin
ICS1892 Data Sheet
Number
Pin
35,
34,
33,
30
37
32
Output
Input/
Type
Pin
© 2000-2001, Integrated Circuit Systems, Inc.
All rights reserved.
Management Data Input/Output.
This pin’s signal is a tri-statable line driven by one of the following:
All transfers and sampling are synchronous with the signal on the MDC
pin.
Receive Clock.
The ICS1892 sources the RXCLK to the MAC/repeater. The ICS1892
uses RXCLK to synchronize the signals on the following pins: RXD0–3,
RXDV, and RXER. The following table contrasts the behavior on the
RXCLK pin when the mode for the ICS1892 is either 10Base-T or
100Base-TX.
Receive Data 0–3.
Note: If the ICS1892 is to be used in an application that uses the
Note: The signal on the RXCLK pin is conditioned by RXTRI.
•
•
•
•
The RXCLK frequency is 2.5 MHz.
The ICS1892 generates RXCLK
from the MDI data stream using a
digital PLL. When the MDI data
stream terminates, the PLL
continues to operate, synchronously
referenced to the last packet
received.
The ICS1892 switches between
clock sources during the period
between when CRS is being
asserted and RXDV is being
asserted. While the ICS1892 locks
onto the incoming data stream, a
clock phase change of up to 360
degrees can occur.
Station management (STA), to transfer command information
The ICS1892, to transfer status information.
RXD0 is the least-significant bit and RXD3 is the most-significant bit of
the MII receive data nibble.
While the ICS1892 asserts RXDV, the ICS1892 transfers the receive
data signals on the RXD0–RXD3 pins to the MAC/Repeater Interface
synchronously on the rising edges of RXCLK.
mechanical MII specification, MDIO must have a 1.5 kΩ ±5%
pull-up resistor at the ICS1892 end and a 2 kΩ ±5% pull-down
resistor at the station management end. (These resistors enable
the station management to determine if the connection is intact.)
10Base-T
110
Chapter 9 Pin Diagram, Listings, and Descriptions
Pin Description
The RXCLK frequency is 25 MHz.
The ICS1892 generates RXCLK
from the MDI data stream while there
is a valid link (that is, either data or
IDLEs). In the absence of a link, the
ICS1892 uses the REFIN clock to
generate the RXCLK.
The ICS1892 switches between
clock sources during the period
between when CRS is being
asserted and RXDV is being
asserted. While the ICS1892 is
bringing up a link, a clock phase
change of up to 360 degrees can
occur.
100Base-TX
February 26, 2001