UJA1069TW24/3V3-T NXP Semiconductors, UJA1069TW24/3V3-T Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
UJA1069TW24/3V3-T
Manufacturer Part Number
UJA1069TW24/3V3-T
Description
Manufacturer
NXP Semiconductors
Datasheet
1.UJA1069TW243V3-T.pdf
(64 pages)
Specifications of UJA1069TW24/3V3-T
Operating Temp Range
-40C to 125C
Operating Temperature Classification
Automotive
Mounting
Surface Mount
Pin Count
24
Lead Free Status / RoHS Status
Compliant
NXP Semiconductors
UJA1069_4
Product data sheet
6.2.6 Sleep mode
6.2.7 Flash mode
The following operations are possible from Standby mode:
In Sleep mode the microcontroller power supply (V1) and the INH/LIMP controlled
external supplies are switched off entirely, resulting in minimum system power
consumption. In this mode, the watchdog runs in Time-out mode or is completely off.
Entering Sleep mode results in an immediate LOW level on pin RSTN, thus stopping any
operation of the microcontroller. The INH/LIMP output is floating in parallel and pin V1 is
disabled. It is also possible for V3 to be ON, OFF or in Cyclic mode to supply external
wake-up switches.
If the watchdog is not disabled in software, it will continue to run and force a system reset
upon overflow of the programmed period time. The SBC enters Start-up mode and pin V1
becomes active again. This behavior can be used for a cyclic wake-up from Sleep mode.
Depending on the application, the following operations can be selected from Sleep mode:
Flash mode can only be entered from Normal mode by entering a specific Flash mode
entry sequence. This fail-safe control sequence comprises three consecutive write
accesses to the Mode register, within the legal windows of the watchdog, using the
operating mode codes 111, 001 and 111 respectively. As a result of this sequence, the
SBC will enter Start-up mode and perform a system reset with the related reset source
information (bits RSS[3:0] = 0110).
•
•
•
•
•
•
•
•
•
•
•
Cyclic wake-up by the watchdog via an interrupt signal to the microcontroller (the
microcontroller is triggered periodically and checked for the correct response)
Cyclic wake-up by the watchdog via a reset signal (a reset is performed periodically;
the SBC provides information about the reset source to allow different start
sequences after reset)
Wake-up by activity on the LIN-bus via an interrupt signal to the microcontroller
Wake-up by bus activity on the LIN-bus via a reset signal
Wake-up by increasing the microcontroller supply current without a reset signal
(where a stable supply is needed for the microcontroller RAM contents to remain valid
and wake-up from an external application not connected to the SBC)
Wake-up by increasing the microcontroller supply current with a reset signal
Wake-up due to a falling edge at pin WAKE forcing an interrupt to the microcontroller
Wake-up due to a falling edge at pin WAKE forcing a reset signal
Cyclic wake-up by the watchdog (only in Time-out mode); a reset is performed
periodically, the SBC provides information about the reset source to allow different
start sequences after reset
Wake-up by activity on the LIN-bus or falling edge at pin WAKE
An overload on V3, only if V3 is in a cyclic or in continuously ON mode
Rev. 04 — 28 October 2009
LIN fail-safe system basis chip
UJA1069
© NXP B.V. 2009. All rights reserved.
11 of 64