LM4548AVH National Semiconductor, LM4548AVH Datasheet - Page 7

• Manufacturer Part Number: LM4548AVH
• Manufacturer: National Semiconductor

Specifications of LM4548AVH

• Single Supply Voltage (typ): 3.3/5V
• Single Supply Voltage (min): 3/4.2V
• Single Supply Voltage (max): 5.5V
• Package Type: LQFP
• Lead Free Status / RoHS Status: Not Compliant

Typical Application
APPLICATION HINTS
• The LM4548A must be initialized by using RESET# to perform a Power On Reset as shown in the Power On Reset Timing
• V
• Don’t leave unused inputs floating. Tie all unused inputs together and connect to Analog Ground through a capacitor (e.g. 0.1
• Do not leave CD_GND floating when using the CD stereo input. CD_GND is the AC signal reference for the CD channels and
• If using a non-standard AC Link controller take care to keep the SYNC and SDATA_IN signals low during Cold Reset to avoid
• The PC_Beep input should be explicitly muted if not used since it defaults to 0 dB gain on reset, unlike the mute default of the
Diagram
µF)
should be connected to the CD source ground (Analog Ground may also be acceptable) through a 1 µF capacitor
entering the ATE or Vendor test modes by mistake
other analog inputs.
REF
must be pulled high to AV
FIGURE 1. LM4548A Typical Application Circuit, Single Codec, 1 Vrms inputs
DD
with a 10 kΩ resistor to ensure correct operation
7
20030003
www.national.com