1382350-1 TE Connectivity, 1382350-1 Datasheet - Page 4

• Manufacturer Part Number: 1382350-1
• Manufacturer: TE Connectivity

Specifications of 1382350-1

• Optical Fiber Type: TX/RX
• Data Transfer Rate: 1250Mbps
• Optical Rise Time: 0.26ns
• Optical Fall Time: 0.26ns
• Jitter: 0.08ns
• Operating Temperature Classification: Commercial
• Peak Wavelength: 845nm
• Package Type: SFP MSA
• Operating Supply Voltage (min): 3.135V
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.465V
• Operating Temp Range: 0C to 70C
• Mounting: Snap Fit To Panel
• Lead Free Status / RoHS Status: Supplier Unconfirmed

4
©
For drawings, technical data or samples, contact your Tyco Electronics sales engineer, call 1-800-522-6752, or visit our Website at:
http://www.tycoelectronics.com/fiberoptics. Specifications subject to change. Consult Tyco Electronics for latest specifications.
Timing Requirements of Control and Status I/O
NOTE:
Parameter
TX Disable Assert Time
TX Disable Negate Time
Time to initialize, including
reset of TX_Fault
TX_Fault Assert Time
TX Disable to reset
LOS Assert Time
LOS Deassert Time
Serial ID Clock Rate
Absolute Maximum Ratings:
Parameter
Storage Temperature
Data Input Voltage
Differential Input Voltage
Supply Voltage
Copyright 2003 by Tyco Electronics Corporation. All Rights Reserved. AMP and Tyco are trademarks. Dimensions are in millimeters with inches
(if shown) in brackets. Other products, logos, and Company names mentioned herein may be trademarks of their respective owners.
For details on timing requirements of control and status I/O parameters, and module interface and data field descriptions, please refer to the
SFP MSA, Appendix B Electrical Interface guidelines.
Gigabit Ethernet Multimode SFP MT-RJ Transceiver
Symbol
T_Off
T_On
T_Init
TX_Fault
T_Reset
T_Loss_On
T_Loss_Off
F_Serial_Clock
Symbol
V
V
V
CC
T
INPUT
DIFF
-V
S
Min
EE
Max
10
1
300
100
10
100
100
100
Units
°C
V
V
V
Unit
µs
ms
ms
µs
µs
µs
µs
kHz
Min
-0.5
-0.2
-40
Condition
Time from rising edge of TX Disable to when
the optical output falls below 10% of nominal
Time from falling edge of TX Disable to when
the modulated optical output rises above 90%
of nominal
From power on or negation of TX_Fault using
TX Disable
Time from fault to TX-Fault on.
Time TX Disable must be held high to reset
TX-Fault
Time from LOS state to LOS assert
Time from non-LOS state to LOS deassert
–
(Continued)
http://www.tycoelectronics.com/fiberoptics
Max
85
V
2.4
5.0
CC
PDF Datasheet 1654843
Only available as PDF at:
Revised 11-03