TCD1305DG(Z,A) Toshiba, TCD1305DG(Z,A) Datasheet - Page 12

• Manufacturer Part Number: TCD1305DG(Z,A)
• Manufacturer: Toshiba
• Type: CCDr

Specifications of TCD1305DG(Z,A)

• Sensor Image Size Range: < 30,720Pixels
• Sensor Image Size: 3648Pixels
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (max): 5.5V
• Operating Temp Range: -25C to 60C
• Package Type: CDIP
• Operating Temperature Classification: Commercial
• Mounting: Through Hole
• Pin Count: 22
• Lead Free Status / RoHS Status: Compliant

CAUTION
1.
2.
3.
4.
5.
allow the glass to dry, by blowing with filtered dry N2. Care should be taken to avoid mechanical or
thermal shock because the glass window is easily to damage.
electricity is sometimes detected. In handing the device, it is necessary to execute the following static
electricity preventive measures, in order to prevent the trouble rate increase of the manufacturing system
due to static electricity.
a.
b.
c.
PRNU of CCD sensor.
effects on prevention of window glass soiling and heat resistance.
within three seconds for lead temperatures of up to 350°C.
Window Glass
Electrostatic Breakdown
Incident Light
Lead Frame Forming
Soldering
The dust and stain on the glass window of the package degrade optical performance of CCD sensor.
Keep the glass window clean by saturating a cotton swab in alcohol and lightly wiping the surface, and
Store in shorting clip or in conductive foam to avoid electrostatic breakdown.
CCD Image Sensor is protected against static electricity, but interior puncture mode device due to static
CCD sensor is sensitive to infrared light. Note that infrared light component degrades resolution and
Since this package is not strong against mechanical stress, you should not reform the lead frame.
We recommend to use a IC-inserter when you assemble to PCB.
Soldering by the solder flow method cannot be guaranteed because this method may have deleterious
Using a soldering iron, complete soldering within ten seconds for lead temperatures of up to 260°C, or
putting on cotton gloves and non-charging working clothes.
work room.
It is not necessarily required to execute all precaution items for static electricity.
It is all right to mitigate the precautions by confirming that the trouble rate within the prescribed
range.
Prevent the generation of static electricity due to friction by making the work with bare hands or by
Discharge the static electricity by providing earth plate or earth wire on the floor, door or stand of the
Ground the tools such as soldering iron, radio cutting pliers of or pincer.
12
TCD1305DG
2004-01-06