IPB70N10SL16XT Infineon Technologies, IPB70N10SL16XT Datasheet - Page 8

• Manufacturer Part Number: IPB70N10SL16XT
• Manufacturer: Infineon Technologies
• Type: Power MOSFETr

Specifications of IPB70N10SL16XT

• Number Of Elements: 1
• Polarity: N
• Channel Mode: Enhancement
• Drain-source On-res: 0.016Ohm
• Drain-source On-volt: 100V
• Gate-source Voltage (max): ±20V
• Drain Current (max): 70A
• Output Power (max): Not RequiredW
• Frequency (max): Not RequiredMHz
• Noise Figure: Not RequireddB
• Power Gain: Not RequireddB
• Drain Efficiency: Not Required%
• Operating Temp Range: -55C to 175C
• Operating Temperature Classification: Military
• Mounting: Surface Mount
• Pin Count: 2 +Tab
• Package Type: TO-263
• Power Dissipation: 250W
• Lead Free Status / RoHS Status: Compliant

IPI70N10SL-16
IPP70N10SL-16, IPB70N10SL-16
Published by
Infineon Technologies AG,
Bereichs Kommunikation
St.-Martin-Strasse 53,
D-81541 München
© Infineon Technologies AG 1999
All Rights Reserved.
Attention please!
The information herein is given to describe certain components and shall not be considered as warranted
characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement,
regarding circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices please contact your nearest
Infineon Technologies Office in Germany or our Infineon Technologies Reprensatives worldwide (see address list).
Warnings
Due to technical requirements components may contain dangerous substances.
For information on the types in question please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express
written approval of Infineon Technologies, if a failure of such components can reasonably be expected to
cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device
or system Life support devices or systems are intended to be implanted in the human body, or to support
2006-02-14
Page 8