ICS8543BGI IDT, Integrated Device Technology Inc, ICS8543BGI Datasheet - Page 13

• Manufacturer Part Number: ICS8543BGI
• Description: IC CLK FAN BUFF MUX 1:4 20TSSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Fanout Buffer (Distribution), Multiplexerr
• Series: HiPerClockS™r

Specifications of ICS8543BGI

• Number Of Circuits: 1
• Ratio - Input:output: 1:4
• Differential - Input:output: Yes/Yes
• Input: CML, HCSL, LVDS, LVHSTL, LVPECL, SSTL
• Output: LVDS
• Frequency - Max: 650MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 20-TSSOP
• Frequency-max: 650MHz
• Number Of Clock Inputs: 2
• Mode Of Operation: Differential
• Output Frequency: 650MHz
• Output Logic Level: LVDS
• Operating Supply Voltage (min): 3.135V
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.465V
• Package Type: TSSOP
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 20
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 8543BGI

Recommendations for Unused Input and Output Pins
Inputs:
CLK/nCLK Inputs
For applications not requiring the use of the differential input, both
CLK and nCLK can be left floating. Though not required, but for
additional protection, a 1kΩ resistor can be tied from CLK to
ground.
PCLK/nPCLK Inputs
For applications not requiring the use of the differential input, both
PCLK and nPCLK can be left floating. Though not required, but for
additional protection, a 1kΩ resistor can be tied from PCLK to
ground.
LVCMOS Control Pins
All control pins have internal pull-ups or pull-downs; additional
resistance is not required but can be added for additional
protection. A 1kΩ resistor can be used.
3.3V LVDS Driver Termination
A general LVDS interface is shown in Figure 5. In a 100Ω
differential transmission line environment, LVDS drivers require a
matched load termination of 100Ω across near the receiver input.
Figure 5. Typical LVDS Driver Termination
IDT™ / ICS™ LVDS FANOUT BUFFER
ICS8543I
LOW SKEW, 1-TO-4, DIFFERENTIAL-TO-LVDS FANOUT BUFFER
3.3V
LVDS Driver
100Ω Differential Transmission Line
50Ω
50Ω
R1
100Ω
13
Outputs:
LVDS Outputs
All unused LVDS output pairs can be either left floating or
terminated with 100Ω across. If they are left floating, there should
be no trace attached.
For a multiple LVDS outputs buffer, if only partial outputs are used,
it is recommended to terminate the unused outputs.
+
–
3.3V
ICS8543BGI REV. E SEPTEMBER 9, 2008