DS1881E-050+ Maxim Integrated Products, DS1881E-050+ Datasheet - Page 11

• Manufacturer Part Number: DS1881E-050+
• Description: IC POT DIGIT DL NV 50K 16TSSOP
• Manufacturer: Maxim Integrated Products

Specifications of DS1881E-050+

• Taps: 64
• Resistance (ohms): 45K
• Number Of Circuits: 2
• Temperature Coefficient: 750 ppm/°C Typical
• Memory Type: Non-Volatile
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Resistance In Ohms: 45K
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

If 10 is entered as the value of the two MSBs of the
Command Byte, then the Configuration Register is to
be modified. The three LSBs of the Configuration
CONFIGURATION REGISTER
Factory Default:
Memory Type:
bits 5, 4, 3
bits 7, 6
bit 2
bit 1
bit 0
b7
1
Dual NV Audio Taper Digital Potentiometer
Configuration Selection: When bit 7 is set to a 1 and bit 6 is set to a 0, the following configuration bits can be set
and stored in EEPROM.
These bits have no function.
Volatile/Nonvolatile Potentiometer Register Control Bit: A control bit that sets the potentiometer registers to be
either volatile or nonvolatile memory.
0 = Potentiometer registers are set to nonvolatile memory storage.
1 = Potentiometer registers are set to volatile memory storage. On power-up, the potentiometer wipers are in the
mute position (default).
Zero-Crossing Detection Enable Bit: A bit used to enable and disable the zero-crossing functionality.
0 = Zero-crossing detection is disabled.
1 = Zero-crossing detection is enabled (default).
Potentiometer Position Configuration: A control bit used to select the number of positions both potentiometers
have.
0 = Potentiometers have 63 positions and mute.
1 = Potentiometers have 33 positions and mute (default).
b6
0
87h
NV (EEPROM)
Configuration Register
b5
X
____________________________________________________________________
b4
X
Register control the NV/volatile wiper setting, the zero-
crossing detection feature, and the potentiometer atten-
uation configuration.
b3
X
CONTROL
V/NV
b2
CROSSING
ZERO-
b1
CONFIG
POT
b0
11