CS43L21-CNZ Cirrus Logic Inc, CS43L21-CNZ Datasheet - Page 25

• Manufacturer Part Number: CS43L21-CNZ
• Description: IC DAC 24BIT 98DB 96KHZ 32QFN
• Manufacturer: Cirrus Logic Inc

Specifications of CS43L21-CNZ

• Package / Case: 32-QFN
• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 2
• Voltage Supply Source: Analog and Digital, Dual ±
• Operating Temperature: -10°C ~ 70°C
• Mounting Type: Surface Mount
• Conversion Rate: 96 KSPS
• Resolution: 24 bit
• Interface Type: Serial
• Operating Supply Voltage: 1.8 V or 2.5 V
• Operating Temperature Range: + 70 C
• Mounting Style: SMD/SMT
• Number Of Dac Outputs: 2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1282 - BOARD EVAL FOR CS43L21 DAC
• Power Dissipation (max): -
• Settling Time: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 598-1187

DS723A1
4.3.2
4.3.3
4.3.4
Volume Controls
Two digital volume control functions offer independent control of the SDIN signal path into the mixer as
well as a combined control of the mixed signals. The volume controls are programmable to ramp in incre-
ments of 0.125 dB at a rate controlled by the soft ramp/zero cross settings.
The signal paths may also be muted via mute control bits. When enabled, each bit attenuates the signal
to its maximum value. When the mute bit is disabled, the signal returns to the attenuation level set in the
respective volume control register. The attenuation is ramped up and down at the rate specified by the
DAC_SZC[1:0] bits.
Mono Channel Mixer
A channel mixer may be used to create a mix of the left and right channels for the SDIN data. This mix
allows the user to produce a MONO signal from a stereo source. The mixer may also be used to imple-
ment a left/right channel swap.
Beep Generator
The Beep Generator generates audio frequencies across approximately two octave major scales. It offers
three modes of operation: Continuous, multiple and single (one-shot) beeps. Sixteen on and eight off
times are available.
Note: The Beep is generated before the limiter and may affect desired limiting performance. If the limiter
function is used, it may be required to set the Beep volume sufficiently below the threshold to prevent the
peak detect from triggering. Since the master volume control, AOUTx_VOL[7:0], will affect the Beep vol-
ume, DAC volume may alternatively be controlled using the PCMMIXx_VOL[6:0] bits.
Software
Controls:
Software
Controls:
Software
Controls:
“PCMX Mixer Volume Control: PCMA (Address 10h) & PCMB (Address 11h)” on page 44“AOUTx
Volume Control: AOUTA (Address 16h) & AOUTB (Address 17h)” on page 49“DAC Output Control
(Address 08h)” on page 41
“PCM Channel Mixer (Address 18h)” on page
(Address 13h)” on page
“Beep Frequency & Timing Configuration (Address 12h)” on page
-10dB
Gain
0dB
dB
Figure 9. De-Emphasis Curve
3.183 kHz
T1=50 µs
F1
46,
“Beep Configuration & Tone Configuration (Address 14h)” on page 47
10.61 kHz
F2
T2 = 15 µs
Frequency
49.
45,
“Beep Off Time & Volume
CS43L21
25