EP4SGX530KH40C2N Altera, EP4SGX530KH40C2N Datasheet - Page 16

• Manufacturer Part Number: EP4SGX530KH40C2N
• Description: IC STRATIX IV FPGA 530K 1517HBGA
• Manufacturer: Altera
• Series: Stratix® IV GXr

Specifications of EP4SGX530KH40C2N

• Number Of Logic Elements/cells: 531200
• Number Of Labs/clbs: 21248
• Total Ram Bits: 27376
• Number Of I /o: 744
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 1517-HBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -

Page 16
Stratix IV GX ES Family Issues
Table 3. Family Issues for Stratix IV GX ES Devices (Part 1 of 3)
Errata Sheet for Stratix IV GX Devices
“PCI Express (PCIe) Gen2 Protocol Link
Establishment Issue”
The PCIe rate switch controller may not be initialized
correctly for the PCIe Gen2 protocol, preventing the
link from being established.
“Quartus II Software Incorrect Setting for
Transceiver CDR in All Modes Except PCIe Mode”
The Quartus II software incorrectly sets the CDR
unit when the transceiver channel is configured in
any mode except PCIe mode and the CDR is
configured to automatic lock mode.
Stratix IV GX Power-up Sequencing on Production Devices
Higher Power Supply Current During Power-Up for V
1
Stratix IV GX devices might fail to power up correctly at low temperatures when the
V
issue occurs because the device fails to exit power-on reset (POR), as indicated by the
nSTATUS pin being stuck low. Configuration cannot begin when the nSTATUS pin is low.
The problem affects all Stratix IV GX devices. Engineering sample devices are not
affected.
Production devices must use the power-up sequence board design modifications to
successfully power-up and exit POR on production devices, by fully powering V
before V
V
You can successfully use the hot socketing feature if you use the V
power sequence board design modification.
Contact Altera
board design changes.
For more information, refer to
V
Table 3
Issue
CC
CCAUX
CCPD
Action: No action is required. Stratix IV GX devices do not support these data
rates in ×N line configurations.
(0.9 V) power supply powers up after the V
and V
lists the specific issues and the affected Stratix IV GX ES devices.
. The published ramp rate specifications still apply.
CCAUX
CCA_L/R
®
begins to ramp. There is no dependency on the ramp rate for V
Technical Support if you require assistance with implementing these
” on page
(ES and Production) Devices
(ES and Production) Devices
“Higher Power Supply Current During Power-Up for
16.
Affected Devices
All Stratix IV GX
All Stratix IV GX
CCAUX
CCPD
(2.5 V) power supply. This
the Quartus II software versions
later. Patches are available for
Quartus II 10.1 SP1 and later.
Quartus II Software 10.1 and
Quartus II software versions
Patches are available for the
and V
9.1 SP2 and 10.0 SP1.
March 2011 Altera Corporation
Stratix IV GX ES Family Issues
9.1 SP2 and 10.1.
CC
Planned Fix
CCA_L/R
before V
CCAUX
CC
CC
and