MC7447AHX1000LB Freescale Semiconductor, MC7447AHX1000LB Datasheet - Page 39

• Manufacturer Part Number: MC7447AHX1000LB
• Description: IC MPU RISC 32BIT 360-FCCBGA
• Manufacturer: Freescale Semiconductor

Specifications of MC7447AHX1000LB

• Processor Type: MPC74xx PowerPC 32-Bit
• Speed: 1.0GHz
• Voltage: 1.3V
• Mounting Type: Surface Mount
• Package / Case: 360-FCCBGA
• Family Name: MPC74xx
• Device Core: PowerPC
• Device Core Size: 32b
• Frequency (max): 1GHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 1.3V
• Operating Supply Voltage (max): 1.35V
• Operating Supply Voltage (min): 1.25V
• Operating Temp Range: 0C to 105C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 360
• Package Type: FCCBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -
• Lead Free Status / Rohs Status: Not Compliant

Table 15
and is relatively unaffected by bus voltage.
9.6
The MPC7447A requires high-resistive (weak: 4.7 KΩ) pull-up resistors on several control pins of the bus
interface to maintain the control signals in the negated state after they have been actively negated and
released by the MPC7447A or other bus masters. These pins are: TS, ARTRY, SHDO, and SHD1.
Some pins designated as being factory test pins must be pulled up to OV
proper device operation. The pins that must be pulled up to OV
pins that must be pulled down to GND are: L1_TSTCLK and TEST[4]. The CKSTP_IN signal should
likewise be pulled up through a pull-up resistor (weak or stronger: 4.7 KΩ–1 KΩ) to prevent erroneous
assertions of this signal.
In addition, the MPC7447A has one open-drain style output that requires a pull-up resistor (weak or
stronger: 4.7 KΩ–1 KΩ) if it is used by the system. This pin is CKSTP_OUT.
If pull-down resistors are used to configure BVSEL, the resistors should be less than 250 Ω (see
Because PLL_CFG[0:4] must remain stable during normal operation, strong pull-up and pull-down
resistors (1 KΩ or less) are recommended to configure these signals in order to protect against erroneous
switching due to ground bounce, power supply noise or noise coupling.
Freescale Semiconductor
summarizes the signal impedance results. The impedance increases with junction temperature
Pull-Up/Pull-Down Resistor Requirements
Z
0
Typical
Maximum
MPC7447A RISC Microprocessor Hardware Specifications, Rev. 5
Impedance
Figure 18. Driver Impedance Measurement
Data
Table 15. Impedance Characteristics
V
DD
= 1.5 V, OV
DD
= 1.8 V ± 5%, T
Pad
R
R
j
OV
OGND
N
P
= 5°–85°C
DD
DD
are: LSSD_MODE and TEST[0:3]; the
Processor Bus
SW2
SW1
33–42
31–51
DD
or down to GND to ensure
System Design Information
Unit
Table
Ω
Ω
12).
39