MPC8572ECVTAULD Freescale Semiconductor, MPC8572ECVTAULD Datasheet - Page 89

• Manufacturer Part Number: MPC8572ECVTAULD
• Description: MPU POWERQUICC III 1023-PBGA
• Manufacturer: Freescale Semiconductor

Specifications of MPC8572ECVTAULD

• Processor Type: MPC85xx PowerQUICC III 32-Bit
• Speed: 1.333GHz
• Voltage: 1.1V
• Mounting Type: Surface Mount
• Package / Case: 1023-FCPBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -

16.5.1
The AC timing and voltage parameters must be verified at the measurement point, as specified within 0.2
inches of the package pins, into a test/measurement load shown in
17 Serial RapidIO
This section describes the DC and AC electrical specifications for the RapidIO interface of the MPC8572E
for the LP-Serial physical layer. The electrical specifications cover both single and multiple-lane links.
Two transmitters (short run and long run) and a single receiver are specified for each of three baud rates,
1.25, 2.50, and 3.125 GBaud.
Two transmitter specifications allow for solutions ranging from simple board-to-board interconnect to
driving two connectors across a backplane. A single receiver specification is given that accepts signals
from both the short run and long run transmitter specifications.
The short run transmitter should be used mainly for chip-to-chip connections on either the same printed
circuit board or across a single connector. This covers the case where connections are made to a mezzanine
(daughter) card. The minimum swings of the short run specification reduce the overall power used by the
transceivers.
The long run transmitter specifications use larger voltage swings that are capable of driving signals across
backplanes. This allows a user to drive signals across two connectors and a backplane. The specifications
allow a distance of at least 50 cm at all baud rates.
All unit intervals are specified with a tolerance of +/– 100 ppm. The worst case frequency difference
between any transmit and receive clock is 200 ppm.
To ensure interoperability between drivers and receivers of different vendors and technologies, AC
coupling at the receiver input must be used.
Freescale Semiconductor
Compliance Test and Measurement Load
The allowance of the measurement point to be within 0.2 inches of the
package pins is meant to acknowledge that package/board routing may
benefit from D+ and D– not being exactly matched in length at the package
pin boundary.
MPC8572E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 5
D+ Package
D+ Package
D– Package
Figure 57. Compliance Test/Measurement Load
+ Package
Silicon
Pin
Pin
Pin
TX
C = C
C = C
NOTE
R = 50 Ω
TX
TX
Figure
R = 50 Ω
57.
Serial RapidIO
89