E2C-CR5B2 Omron, E2C-CR5B2 Datasheet - Page 10

• Manufacturer Part Number: E2C-CR5B2
• Description: Proximity Sensors SEP.AMP.PROX. 2MM 1.2mm DIST
• Manufacturer: Omron
• Type: Inductive Proximity Sensorr
• Series: E2Cr

Specifications of E2C-CR5B2

• Maximum Operating Temperature: + 55 C
• Operating Supply Voltage: 10 V to 26.4 V
• Sensing Distance: 0.5 mm
• Minimum Operating Temperature: 0 C
• Sensor Type: Inductive
• Sensing Object: Metallic
• Response Frequency: 1kHz
• Material - Body: Stainless Steel
• Shielding: Shielded
• Voltage - Supply: -
• Output Type: -
• Terminal Type: 2-Wire
• Package / Case: Cylinder
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

E2C-T
Sensitivity Setting (Automatic Teaching) in Detail
Note: Be sure to perform the teaching of the E2C-T before use. Once the teaching of the E2C-T is performed, the teaching data set in
10
Type of teaching
Teaching without
a target object
Teaching with and
without a target
object
Positioning
teaching
the E2C-T will be retained even after turning OFF the E2C-T.
Procedure
:
:
:
1. Locate the Sensor Head in sensing distance range.
2. Set the mode selector to T.
3. Press the TEACH button once without a target object.
4. Set the mode selector to RUN to complete the teaching operation.
1. Locate the Sensor Head in sensing distance range.
2. Set the mode selector to T.
3. Move the target object to the position where the output should turn OFF. Then press the TEACH button once.
4. Move the target object to the position where the output should turn ON. Then press the TEACH button once.
5. Set the mode selector to RUN to complete the teaching operation.
1. Locate the Sensor Head in sensing distance range.
2. Set the mode selector to T.
3. Press the TEACH button once without a target object. (First time)
4. Move the target object to the position where the output should turn ON. Then press the TEACH button once.
5. Press the teaching button once without changing the position of the target object. (Third time)
6. Set the mode selector to RUN to complete the teaching operation.
(First time)
(Second time)
(Second time)
Check the connection of the sensor cable and make sure that there is no target object. Then repeat
steps 3 and 4.
Check the connection of the sensor cable and change the position of the target object and the set
distance. Then repeat steps 3 through 5.
Check the connection of the sensor cable and change the position of the target object and the set
distance. Then repeat steps 3 through 6.
Teaching is not OK
Teaching is not OK
Teaching is not OK
Teaching is OK
Teaching is OK
Teaching is OK
Teaching is OK
Teaching is OK
Teaching is OK
Wait for 1 s
Wait for 1 s
Wait for 1 s
Wait for 1 s
Wait for 1 s
Wait for 1 s
Green indicator is ON, then both the orange and green
indicators are ON.
Orange indicator is ON, then the green indicator is ON.
Orange indicator is ON, then the green indicator is ON.
Orange teaching indicator flashes.
Orange teaching indicator flashes.
Orange teaching indicator flashes.
Orange teaching indicator is ON.
Orange teaching indicator is ON.
Orange teaching indicator is ON.
E2C-T