E2C-CR5B2 Omron, E2C-CR5B2 Datasheet - Page 5

• Manufacturer Part Number: E2C-CR5B2
• Description: Proximity Sensors SEP.AMP.PROX. 2MM 1.2mm DIST
• Manufacturer: Omron
• Type: Inductive Proximity Sensorr
• Series: E2Cr

Specifications of E2C-CR5B2

• Maximum Operating Temperature: + 55 C
• Operating Supply Voltage: 10 V to 26.4 V
• Sensing Distance: 0.5 mm
• Minimum Operating Temperature: 0 C
• Sensor Type: Inductive
• Sensing Object: Metallic
• Response Frequency: 1kHz
• Material - Body: Stainless Steel
• Shielding: Shielded
• Voltage - Supply: -
• Output Type: -
• Terminal Type: 2-Wire
• Package / Case: Cylinder
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

J INDICATORS
The OUT indicator indicates the status of the control output transistor. The indicator will be ON when the transistor has control output (i.e.,
NPN open collector output).
If the operation selector is set to NO, the indicator will be ON when the target object is in the sensing distance range. If the operation se-
lector is set to NC, the indicator will be ON when the target object is not in the sensing distance range.
The STB (stability) indicator indicates the excess gain of object detection or non-detection. The indicator will be ON when the target object
is within approximately 93% of the sensing distance or at approximately 107% of the sensing distance or beyond.
Nomenclature
J SWITCHES AND FUNCTIONS
E2C-T
Mode Selector
T: Teaching mode is set, The output
RUN: RUN mode is set.
STB (Stability) Indicator (Green)
Also used for teaching monitor purposes.
transistor is turned OFF.
Set to NC
NC: Normally closed
NO: Normally open
OFF
Operation Selector
Transistor output
(NPN open collector)
ON
Operation Indicator
(Orange)
OUT indicator (orange)
Set to NO
OFF
ON
Cable (connector) side
STB (stability)
indicator (green)
OFF
ON
Front side
ON
Approx. 107% of sensing distance
Sensing distance
Approx. 93% of sensing distance
Sensor Connection
Terminal (shielded ground)
Sensor Connection Terminal (conductor)
TEACH Button
Cable Length Selector
Cable Length Compensator
Set this switch according to the
cable length as shown in the table
below.
Applicable
Sensor Head
E2C-CR5B2
E2C-CR8A
E2C-CR8B
E2C-X1A
E2C-C1A
E2C-X1R5A
Setting
3 m
1 m
2 m
3 m
Cable length
3 m
0 to 1 m
1 to 2 m
2 to 3 m
E2C-T
5