PIC18F24J10-I/SS Microchip Technology Inc., PIC18F24J10-I/SS Datasheet - Page 40

• Manufacturer Part Number: PIC18F24J10-I/SS
• Description: Microcontroller; 16 KB Flash; 1024 RAM; 0 EEPROM; 21 I/O; 28-Pin-SSOP
• Manufacturer: Microchip Technology Inc.

Specifications of PIC18F24J10-I/SS

• A/d Inputs: 10-Channel, 10-Bit
• Comparators: 2
• Cpu Speed: 10 MIPS
• Eeprom Memory: 0 Bytes
• Input Output: 21
• Interface: I2C/SPI/USART
• Memory Type: Flash
• Number Of Bits: 8
• Package Type: 28-pin SSOP
• Programmable Memory: 16K Bytes
• Ram Size: 1K Bytes
• Speed: 40 MHz
• Timers: 1-8-bit, 2-16-bit
• Voltage, Range: 2-5.5 V
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

PIC18F45J10 FAMILY
REGISTER 4-1:
DS39682B-page 38
bit 7
bit 6-5
bit 4
bit 3
bit 2
bit 1
bit 0
RCON: RESET CONTROL REGISTER
bit 7
IPEN: Interrupt Priority Enable bit
1 = Enable priority levels on interrupts
0 = Disable priority levels on interrupts (PIC16CXXX Compatibility mode)
Unimplemented: Read as ‘0’
RI: RESET Instruction Flag bit
1 = The RESET instruction was not executed (set by firmware only)
0 = The RESET instruction was executed causing a device Reset (must be set in software after
TO: Watchdog Time-out Flag bit
1 = Set by power-up, CLRWDT instruction or SLEEP instruction
0 = A WDT time-out occurred
PD: Power-Down Detection Flag bit
1 = Set by power-up or by the CLRWDT instruction
0 = Set by execution of the SLEEP instruction
POR: Power-on Reset Status bit
1 = A Power-on Reset has not occurred (set by firmware only)
0 = A Power-on Reset occurred (must be set in software after a Power-on Reset occurs)
BOR: Brown-out Reset Status bit
1 = A Brown-out Reset has not occurred (set by firmware only)
0 = A Brown-out Reset occurred (must be set in software after a Brown-out Reset occurs)
Legend:
R = Readable bit
-n = Value at POR
R/W-0
Note:
IPEN
Note 1: It is recommended that the POR bit be set after a Power-on Reset has been
a Brown-out Reset occurs)
2: If the on-chip voltage regulator is disabled, BOR remains ‘0’ at all times. See
3: Brown-out Reset is said to have occurred when BOR is ‘0’ and POR is ‘1’
BOR is not available in PIC18LF2XJ10/4XJ10 devices.
detected, so that subsequent Power-on Resets may be detected.
Section 4.4.1 “Detecting BOR” for more information.
(assuming that POR was set to ‘1’ by software immediately after POR).
U-0
—
U-0
Preliminary
—
W = Writable bit
‘1’ = Bit is set
R/W-1
RI
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
R-1
TO
R-1
PD
© 2006 Microchip Technology Inc.
x = Bit is unknown
R/W-0
POR
R/W-0
BOR
bit 0