MCP795W10-I/SL Microchip Technology, MCP795W10-I/SL Datasheet - Page 2

• Manufacturer Part Number: MCP795W10-I/SL
• Description: SPI GPP RTCC, 1Kb EE, 64B SRAM, WD Timer, Event Detect, ID 14 SOIC .150in TUBE
• Manufacturer: Microchip Technology

MCP795WXX/MCP795BXX
Description:
The MCP795XXX is a low-power Real-Time Clock/
Calendar (RTCC) that uses digital trimming compen-
sation for an accurate clock/calendar, an interrupt out-
put to support alarms and events, a power sense
circuit that automatically switches to the backup sup-
ply, nonvolatile memory for safe data storage and sev-
eral
requirements.
Along with a low-cost 32,768 kHz crystal, this RTCC
tracks time using several internal registers and then
communicates the data over a 10 MHz SPI bus that is
fast enough to support a programmable millisecond
alarm.
The device is fully accessible through the serial inter-
face, while V
operate down to 1.3V through the backup supply con-
nected to the V
retention only.
As part of the power sense circuit, a time saver
function is implemented to store the time when main
power is lost and again, when power is restored to log
the duration of a power failure.
Along with the on-board serial EEPROM and battery-
backed SRAM, a 128-bit protected space is available
for a unique ID. This space can be ordered
preprogrammed with a MAC address, or blank for the
user to program.
This clock/calendar automatically adjusts for months
with fewer than 31 days including corrections for leap
years. The clock operates in either 24-hour or 12-hour
format with AM/PM indicator and settable alarm(s).
Using the external crystal, the CLKOUT pin can be set
to generate a number of output frequencies. In
addition, the MCP795BXX devices support a 32 kHz
clock output at power-up on the CLKOUT/BOOT pin
by using the same crystal driving the RTCC device.
For
programmable pulse count can identify the 1
16
second event detect with built-in debounce input filter
was also implemented to support noisy mechanical
switches.
Since many microcontrollers do not have an integrated
Watchdog Timer, this peripheral has been imple-
mented in the RTCC. For many applications, this
function must be performed outside the microcontroller
for increased robustness.
DS22280B-page 2
th
or 32
versatility,
enhanced
nd
CC
pulse before sending an interrupt. A
BAT
is between 1.8V and 5.5V, but can
a
features
input for timekeeping and SRAM
digital
event
that
support
detect
with
system
st
, 4
Preliminary
th
a
,
FIGURE 1-1:
V
IRQ
V
WD
CS
X1
X2
BAT
SS
WDT
OSC
 2011-2012 Microchip Technology Inc.
TIME-STAMP
BLOCK DIAGRAM
EEPROM
SRAM
CLKOUT Divider
ID
SPI
CLKOUT/
BOOT
EVHS
EVLS
SCK
SDO
V
SDI
CC