STEVAL-ILL029V2 STMicroelectronics, STEVAL-ILL029V2 Datasheet - Page 24

• Manufacturer Part Number: STEVAL-ILL029V2
• Description: BOARD & REF DESIGN
• Manufacturer: STMicroelectronics
• Series: -r

Specifications of STEVAL-ILL029V2

• Main Purpose: Touch Interface, LED Driver
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: STLED325, STM8S, STMPE24M31
• Primary Attributes: 4 Digit 7-Segment LEDs, 8 Discrete LEDs, 8 Touch Pads, 8-Channel Touch Wheel
• Secondary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

System controller
SYSCON-2
Address:
Type:
Reset:
Description:
24/85
7
[7:5] SCLK_DIV: Sensor clock divider.
[4:3] PCLK_DIV: PWM clock divider
[2] GPIO_CLK: GPIO clock disable
[1] PMW_CLK: PWM clock disable
[0] CS_CLK: Capacitive sensor clock disable
SCLK_DIV
RW
6
1
000, 001, 010: RESERVED
011: 64
100: 128
101: 256
110: 512
111: 1024
Sensor clock is 2 MHz / ( PRBS_Factor * SCLK_DIV[2:0] )
PRBS factor = 4.5
00 for 16 kHz
01 for 32 kHz
10 for 64 kHz
11 for 128 kHz
Write “1” to diWrite “1“ to disable the clock to GPIO module.
When clock to GPIO module is disabled, access to GPIO module register will not work correctly.
Write “1“ to disable the clock to PWM module.
When clock to PWM module is disabled, access to PWM module register will not work correctly.
Write “1“ to disable the clock to capactive sensor module
When clock to touch module is disabled, access to touch module registers will not work
correclty.
0x04
R/W
0xFE
Sensor and PWM clock divider. The SYSCON-2 register controls the sensor and
PWM clock speed, and the clock gating of various functional modules.
This bit will always read '0'. as the I2C transaction to read this bit will wake up the
device from hibernate mode.
5
Doc ID 16174 Rev 3
4
PCLK_DIV
RW
1
3
Sensor and PWM clock divider
GPIO_CLK
2
STMPE16M31, STMPE24M31
RW
1
PWM_CLK
1
CS_CLK
RW
0
0