R88A-CAWE020B Omron, R88A-CAWE020B Datasheet - Page 299

• Manufacturer Part Number: R88A-CAWE020B
• Description: POWER CABLE W/BRAKE 20M
• Manufacturer: Omron

Specifications of R88A-CAWE020B

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88ACAWE020B

Operation
• When set to 7, the servo turns ON after the power has been turned ON. You cannot use the jog opera-
• Settings are the same as for Pn50A.1.
• If Pn50A.0 is set to 0, you cannot change the pin number. Settings 0 to 6 and 9 to F are disabled, and all
• To change the pin number, set Pn50A.0 to 1.
• Settings are the same as for Pn50A.1.
• If Pn50A.0 is set to 0, you cannot change the pin number. Settings 0 to 6 and 9 to F are disabled, and all
• To change the pin number, set Pn50A.0 to 1.
• If set to 7 (always ON), the servo is in always overtravel status (i.e., forward rotation is always drive-
• If set to 8 (always OFF), the servo drive prohibition is OFF (i.e., the forward rotation drive is permitted).
• The POT signal permits forward rotation drive upon input.
• Settings are the same as for Pn50A.1.
• If Pn50A.0 is set to 0, you cannot change the pin number. Settings 0 to 6 and 9 to F are disabled, and all
• To change the pin number, set Pn50A.0 to 1.
• If set to 7 (always ON), the servo is in always in overtravel status (i.e., reverse rotation is always drive-
• If set to 8 (always OFF), the servo drive prohibition is OFF (i.e., the reverse rotation drive is permitted).
• The NOT signal permits reverse rotation drive upon input.
• Settings are the same as for Pn50A.1.
• If Pn50A.0 is set to 0, you cannot change the pin number. Settings 0 to 6 and 9 to F are disabled, and all
• To change the pin number, set Pn50A.0 to 1.
Pn50A.2
Setting
range
Pn50A.3
Setting
range
Pn50b.0
Setting
range
Pn50b.1
Setting
range
tion with this setting.
are set to CN1, pin 41 enabled by L input. Settings 7 and 8 are both enabled.
are set to CN1, pin 42 enabled by L input. Settings 7 and 8 are both enabled.
prohibited).
are set to CN1, pin 43 enabled by L input. Settings 7 and 8 are both enabled.
prohibited).
are set to CN1, pin 44 enabled by L input. Settings 7 and 8 are both enabled.
Input signal selection 1 –– MING signal (gain reduction) input terminal allocation (Position,
speed, internally-set speed control)
0 to F
Input signal selection 1 –– POT signal (forward drive prohibited) input terminal allocation (All
operation modes)
0 to F
Input signal selection 2 –– NOT signal (reverse drive prohibited) input terminal allocation (All
operation modes)
0 to F
Input signal selection 2 –– RESET signal (alarm reset) input terminal allocation (All operation
modes)
0 to F
Unit
Unit
Unit
Unit
---
---
---
---
Default
setting
Default
setting
Default
setting
Default
setting
1
8
8
4
Restart
power?
Restart
power?
Restart
power?
Restart
power?
Chapter 4
Yes
Yes
Yes
Yes
4-39