SI3015-F-FS Silicon Laboratories Inc, SI3015-F-FS Datasheet - Page 22

• Manufacturer Part Number: SI3015-F-FS
• Description: IC ISOMODEM LINE-SIDE 16SOIC
• Manufacturer: Silicon Laboratories Inc
• Type: Chipsetr

Specifications of SI3015-F-FS

• Package / Case: 16-SOIC (3.9mm Width)
• Data Format: V.90
• Interface: Serial
• Voltage - Supply: 3.3 V ~ 5 V
• Mounting Type: Surface Mount
• Product: Modem Chip
• Supply Voltage (min): 3 V
• Supply Current: 26 mA
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Baud Rates: -
• Lead Free Status / Rohs Status: Compliant

Si2403
22
Command
Sn=x
Sn?
Mn
M0
M1
M2
M3
On
O0
O1
O2
Qn
Q0
Q1
Sn
S$
Vn
V0
V1
Xn
X0
X1
X2
X3
X4
I0
I1
I3
I6
I7
I8
R
Table 8. Basic AT Command Set (Command Defaults in Bold) (Continued)
Display Si2403 revision code.
B: Revision B
C: Revision C, etc.
Display Si2403 firmware revision code (numeric).
Display line-side revision code.
15F
Display the Si2403 model number.
“2403”
Diagnostic Results 1. See “AN70: Si2456/Si2433/Si2414/Si2403 Modem Designer’s Guide” for
details.
Diagnostic Results 2. See AN70 for details.
Speaker operation (via AOUT).
Speaker is always off.
Speaker is on while dialing and handshaking; off in Data mode.
Speaker is always on.
Speaker is off while dialing; on during handshaking and retraining.
Return to Data mode from command mode operation.
Return to Data mode.
Return to Data mode and perform a full retrain (at any speed except 300 bps).
Return to Data mode and perform rate renegotiation.
Response mode.
Enable result codes (see Table 12 on page 32)
Disable result codes (enable quiet mode).
Initiate V.23 reversal.
S-register operation (see Table 13 on page 33).
List contents of all S registers.
Display contents of S-register n.
Set S-register n to value x (where n and x are decimal values).
Result code type (see Table 12 on page 32).
Numeric result codes.
Verbal result codes
Call Progress Monitor (CPM)—This command controls which CPM signals are monitored and
reported to the host from the Si2403. (See Table 12 on page 32.)
Basic results; disable CPM—Blind dial (does not wait for dial tone). CONNECT message does
not include speed.
Extended results; disable CPM—Blind dial. CONNECT message includes speed.
Extended results and detect dial tone only—Add dial tone detection to X1 mode. Does not blind
dial.
Extended results and detect busy only—Add busy tone detection to X1 mode.
Extended results, full CPM—Full CPM enabled, CONNECT message includes speed.
=
Si3015 Revision F
=
Si2403
Rev. 1.2
Action