DS8007A-EAG+ Maxim Integrated Products, DS8007A-EAG+ Datasheet - Page 14

• Manufacturer Part Number: DS8007A-EAG+
• Description: IC INTERFACE SMART CARD 48-LQFP
• Manufacturer: Maxim Integrated Products

Specifications of DS8007A-EAG+

• Applications: Smart Card
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 6 V
• Package / Case: 48-LQFP
• Mounting Type: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Multiprotocol Dual Smart Card Interface
In the multiplexed mode of operation, the D7–D0 sig-
nals are multiplexed between address and data. The
falling edge of the address latch enable (ALE) signal
from the host microcontroller latches the address
(D3–D0), and the RD and WR strobe input signals are
used to enable a read or write operation, respectively, if
the DS8007A is selected (i.e., CS = 0). See the AC tim-
ing for the multiplexed parallel bus mode found earlier
in this data sheet.
Figure 7. Parallel Bus Interface
14
______________________________________________________________________________________
D7–D0
WR
CS
RD
ALE
RST
CS
LOGIC
OR
V
DD
Multiplexed Mode
AD3–AD0
RST
LATCH
CONTROL
D3–D0
In the nonmultiplexed mode of operation, the address is
always provided on the AD3–AD0 signals, and the data
is always transacted on the D7–D0 signals. The RD input
signal is used as a read/write (R/W) operation select. The
WR and CS input signals serve as active-low enables,
and must be asserted for the read or write operation to
take place. See the AC timing for the nonmultiplexed
parallel bus mode found earlier in this data sheet.
1
0
REGISTERS
Nomultiplexed Mode