ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 113

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

The "ISPnano Series III ATE" is a state-of-the-art ISP Programmer designed for high-speed In-
System Programming (ISP) of FLASH Microcontrollers and Serial Memory devices in a production
environment. It has been specially developed to allow simple integration with Automatic Test
Equipment (ATE) systems and In-Circuit Testers (ICTs) used in high-volume production systems.
The programmer supports automated relay switching of all Target System programming and power
signal lines between an external ATE / ICT system and the programmer. This allows it to be
completely out-of-circuit during normal ATE testing operation. A dedicated 'ATE Interface' also allows
the ATE / ICT to control the operation of the programmer in 'Standalone Mode' (no PC required).
Features
ISPnano Series Programmer - User Manual – V1.11 – 12
•
•
•
•
•
•
•
•
•
•
•
Integrated ‘ISPnano Series 3’ programmer (see separate features for this module)
Compact enclosure featuring integrated programmer and relay switching module
All programmer I/O signal lines are isolated from both the Target System (UUT) and ATE / ICT
via relays
All power lines (Target Vcc, Target Vpp and GROUND) are independently switched via relays.
The ATE / ICT is routed to the Target System (UUT) by default so the programmer is
completely isolated from the UUT.
When a programming operation starts, the Target System (UUT) ISP I/O and power signals
are automatically switched to the programmer and the ATE / ICT is then completely isolated
from the programmer.
At the end of a programming operation, the Target System (UUT) is automatically re-
connected to the ATE / ICT.
Simple integration with ATE / ICT as the programmer controls the relay switching
‘RELAYS ON’ indicator signals when the programmer is connected to the Target System
(UUT)
An external +12V supply is required to power the relay coils (Connect to EXT-VCC connector
on the programmer)
Supports signal routing of an external ‘JTAG Boundary Scan Tester’ via the ATE Port to the
Target System (UUT).
th
May 2011
97