ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 35

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

1.11 Programmer Specifications
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
1
2
3
4
5
6
7
10 PC Control Software The programmer can be controlled using:
ISPnano Series Programmer - User Manual – V1.11 – 12
Parameter
Target Device
Support
Target Device
Programming
Interfaces
Operating modes
On-board FLASH
Memory Store
Project storage in
Memory Store
Keypad entry
Status LED’s
Description / comment
See Device Support List (separate document)
The ISPnano Series I and II programmers supports the
following programming interfaces:
The ISPnano Series III programmer supports all of the above
programming interfaces plus the following additional interfaces:
The programmer supports the following operating modes:
•
•
•
•
•
•
•
•
1 x <START> button
64 x Programming Projects
•
•
•
•
•
•
•
•
•
Development Mode (PC controlled)
Project Upload Mode (PC controlled)
Standalone Mode – Single Start button mode
Standalone Mode – Automatic Target Connect / Disconnect
Sensing
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
Standalone Mode - Remote Controlled via 4-wire TTL
Remote Control Port
PC controlled via ISP-PRO software (chargeable upgrade)
PC controlled via ConsoleEDS utility (chargeable upgrade)
•
i.
ii.
iii.
•
Atmel Low Voltage SPI
Atmel High Voltage SPI (+12V Vpp)
Atmel AVR JTAG (chargeable update)
Atmel (formerly Temic) 8051 Boot loader ISP
NXP (Philips) 8051 - Boot Loader ISP
Generic I2C (SDA + SCL)
ARM7 JTAG Debug Interface
Atmel XMEGA 2-wire PDI interface
Atmel ATtiny 2-wire TPI interface
128 Mbits (16 MBytes) FLASH Memory for Project
Storage
EQTools (as standard)
3 x Status LED’s located on the programmer:
3 x remote Status LED’s can also be connected off-
board on a Test Fixture via the ‘Remote System
Status’ port.
1 x Bi-coloured status LED
<PASS>, <BUSY>, <FAIL>
th
May 2011
Refer
to
section
19