ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 48

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

2.6 ASCII Text Communications Mode
2.6.1 Overview
The ‘ASCII Text Control’ communications protocol or ‘ATC’ is designed as a simple way for a
Remote Test System to control the basic programming operations of an Equinox programmer via an
RS-232 serial link. It is an ‘ASCII’ protocol with simple commands to initiate programming of pre-
loaded ‘Standalone Programming Projects’ which are stored in the on-board ‘FLASH Memory
Store’ of the programmer. The protocol supports up to 64 independent Programming Projects per
programmer, but is limited to one programmer.
Implementation of this protocol is straightforward due to the limited number of commands and
restricted functionality. As this is an ASCII protocol, it can be quickly evaluated using any Terminal
Emulation Software Utility such as Hyperterminal.
2.6.2 Limitations of this protocol
This protocol has been designed as a simple method to allow a Remote Application such as an In-
Circuit Tester to control the basic operations of an Equinox programmer. The programmer only
supports the programming of entire ‘Programming Projects’ which are already uploaded to the
programmer on-board FLASH memory. This protocol does not support writing / reading of individual
bytes or blocks of data to / from a Target Device.
The limitations of this protocol are as follows:
2.6.3 Further Information
A full description of this protocol can be found in the following Application Note:
‘AN110 - ASCII Text Control (ATC) Protocol for Remote Control of Equinox Programmers’.
32
1. The protocol only supports programming of Programming Projects which are pre-loaded into
2. The protocol does not support writing / reading of individual bytes or blocks of data to / from a
3. The protocol does not support uploading of ‘Standalone Programming Projects’ to the
4. Only very limited diagnostics are available using this protocol ie. FAIL + Error Number.
the Programmer on-board FLASH Memory Store.
Target Device.
programmer. This must be performed using the ‘EQTools – Project Upload Wizard’.
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011