RN-XV Roving Networks Inc, RN-XV Datasheet - Page 25

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

set wlan linkmon <value>
set wlan mask <value>
set wlan num <value>
set wlan phrase <string>
www.rovingnetworks.com
809 University Avenue
•
Los Gatos, CA 95032
sets the link monitor timeout threshold. If set to 1 or more, WiFly will
scan once per second for the AP it is associated with. The value is the
threshold of failed scans before the WiFly declares “AP is Lost”, de-
authenticates. The WiFly will retry the association based on the join
policy variable. A value of 5 is recommended, as some APs will not
always respond to probes. Default is 0 (disabled). Without this feature,
there is no way to detect an AP is no longer present until it becomes
available again (if ever).
sets the wlan channel mask used for scanning channels with the auto-join
policy 1 or 2, used when the channel is set to 0. Value is a bit-map where
bit 0 = channel 1. Input for this command can be entered in decimal or
hex if prefixed with 0x. Default value is 0x1FFF (all channels)
sets the default WEP key to use. 1-4 is the valid range.
Example : “set w n 2” sets the default key to 2.
sets the passphrase for WPA and WPA2 security modes. 1-64 chars. The
passphrase can be alpha and numeric, and is used along with the SSID to
generate a unique 32 byte Pre-shared key (PSK), which is then hashed into
a 256 bit number. Changing either the SSID or this value re-calculates
and stores the PSK.
If exactly 64 chars are entered, it is assumed that this entry is already an
ASCII HEX representation of the 32 byte PSK and the value is simply
stored.
For passphrases that contain spaces use the replacement character $
instead of spaces. For example “my pass word” would be entered
“my$pass$word”. The replacement character can be changed using the
optional command set opt replace <char>.
Example : “set w p password” sets the phrase.
~ 25 ~
•
Tel [phone]
• [e-mail]
WiFly-RN-UM
WiFly GSX/EZX
5/4/2011