RN-XV Roving Networks Inc, RN-XV Datasheet - Page 69

• Manufacturer Part Number: RN-XV
• Description: MODULE 802.11B/G 2.4GHZ
• Manufacturer: Roving Networks Inc
• Series: -r

Specifications of RN-XV

• Frequency: 2.4GHz
• Data Rate - Maximum: 54Mbps
• Modulation Or Protocol: 802.11b/g
• Applications: General Purpose
• Power - Output: 12dBm
• Sensitivity: -83dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Through Hole
• Memory Size: -
• Antenna Connector: On-Board, Wire Antenna
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1044; RN-XV-W; RN-XVEE; XVEE

WiFly GSX/EZX
www.rovingnetworks.com
WiFly-RN-UM
5/4/2011
17. Analog Sensor Capability
The WiFly-GSX has 8 analog sensor inputs that can be driven between 0 to 1.2VDC. The analog inputs are
sampled and the digital value read by using the show q <channel> command.
Warning: Driving these inputs above 1.2V will cause permanent damage.
The hardware specifications of the analog input is:
Input voltage range: 0 - 1.2 V, however the A2D saturates at 400mV.
Resolution:
14 bits = 12uV
Sampling frequency: 35us
Accuracy:
5% un-calibrated
The accuracy of each analog sensor reading can be offset by up to 5% due to variation from chip to chip. To
improve accuracy it is recommend using a precision reference voltage on one of the analog inputs to
calculate the offset. The offset will be the same for all analog inputs.
For example,
- drive precision 200mV reference on analog input 4.
- read analog input 4 and compute the offset.
If you read 210mv you would know that the offset is +10mv.
When you read input 5 you would subtract 10mv from the result.
To read a sensor pin, send the following command:
show q <channel>
Channel is the analog sensor input from 0 to 7. The value for the analog sensor input is measured in
microvolts and is returned as 8xxxxx. The 8 in front is a start marker.
You can also sample multiple channels by using a bit mask:
show q 0x1<mask>
where mask is a bit mask of the channels.
For example, to read channels 0, 1, and 7, send:
show q 0x183
The return values are the format: 8<chan0>, 8<chan1>, 8<chan7>\r\n
•
•
• [e-mail]
809 University Avenue
Los Gatos, CA 95032
Tel [phone]
~ 69 ~