TDA8601 NXP Semiconductors, TDA8601 Datasheet - Page 15

• Manufacturer Part Number: TDA8601
• Manufacturer: NXP Semiconductors

Specifications of TDA8601

• Lead Free Status / Rohs Status: Compliant

Philips Semiconductors
14. Handling information
15. Soldering
9397 750 13713
Product data sheet
15.2.1 Soldering by dipping or by solder wave
15.2.2 Manual soldering
15.3.1 Reflow soldering
15.1 Introduction
15.2 Through-hole mount packages
15.3 Surface mount packages
Inputs and outputs are protected against electrostatic discharge in normal handling.
However, to be completely safe, it is desirable to take normal precautions appropriate to
handling integrated circuits.
This text gives a very brief insight to a complex technology. A more in-depth account of
soldering ICs can be found in our Data Handbook IC26; Integrated Circuit Packages
(document order number 9398 652 90011).
There is no soldering method that is ideal for all IC packages. Wave soldering is often
preferred when through-hole and surface mount components are mixed on one
printed-circuit board. Wave soldering can still be used for certain surface mount ICs, but it
is not suitable for fine pitch SMDs. In these situations reflow soldering is recommended.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing.
Typical dwell time of the leads in the wave ranges from 3 seconds to 4 seconds at 250 C
or 265 C, depending on solder material applied, SnPb or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Reflow soldering requires solder paste (a suspension of fine solder particles, flux and
binding agent) to be applied to the printed-circuit board by screen printing, stencilling or
pressure-syringe dispensing before package placement.
Rev. 03 — 23 September 2004
RGB/YUV and fast blanking switch
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
stg(max)
TDA8601
). If the
15 of 20