MB15F72ULPFT-G-BND Fujitsu Components, MB15F72ULPFT-G-BND Datasheet - Page 11

• Manufacturer Part Number: MB15F72ULPFT-G-BND
• Manufacturer: Fujitsu Components

Specifications of MB15F72ULPFT-G-BND

• Lead Free Status / Rohs Status: Not Compliant

3. Power Saving Mode (Intermittent Mode Control Circuit)
Notes • When power (V
Normal mode
Power saving mode
The intermittent mode control circuit reduces the PLL power consumption.
By setting the PS pins low, the device enters into the power saving mode, reducing the current consumption.
See the Electrical Characteristics chart for the specific value.
The phase detector output, Do, becomes high impedance.
For the dual PLL, the lock detector, LD, is as shown in the LD Output Logic table.
Setting the PS pins high, releases the power saving mode, and the device works normally.
The intermittent mode control circuit also ensures a smooth startup when the device returns to normal operation.
When the PLL is returned to normal operation, the phase comparator output signal is unpredictable. This is
because of the unknown relationship between the comparison frequency (fp) and the reference frequency (fr)
which can cause a major change in the comparator output, resulting in a VCO frequency jump and an increase
in lockup time.
To prevent a major VCO frequency jump, the intermittent mode control circuit limits the magnitude of the error
signal from the phase detector when it returns to normal operation.
• PS pins must be set at “L” at Power-ON.
Status
(1) PS
(2) Set serial data at least 1 µs after the power supply becomes stable (V
(3) Release power saving mode (PS
data.
IF
= PS
CC
V
Clock
Data
LE
PS
PS
) is first applied, the device must be in standby mode, PS
CC
PS
IF
RF
RF
IF
= “L” (power saving mode) at Power-ON
/PS
H
L
RF
pins
(1)
OFF
t
IF
V
, PS
1 s
RF
ON
(2)
: “L” → “H”) at least 100 ns after setting serial
t
PS
(3)
> 100 ns
IF
= PS
MB15F72UL
RF
CC
= Low, for at least 1 µs.
≥ 2.2 V) .
11