F10-S30R Omron, F10-S30R Datasheet - Page 20

• Manufacturer Part Number: F10-S30R
• Description: 25C4243
• Manufacturer: Omron

Specifications of F10-S30R

• Sensing Range: 90mm To 110mm
• Peak Reflow Compatible (260 C): No
• Terminal Type: Wire Leaded
• Supply Current Max: 150mA
• Supply Voltage Max: 19.8VDC
• Sensor Terminals: Cable
• Leaded Process Compatible: No
• Rohs Compliant: No

F10
Precautions
Setup
The F10-Cj Amplifier radiates heat. If more than one Unit is
installed side-by-side, make sure that there is a minimum space of
5 mm between adjacent Units as shown below.
Do not disconnect or connect the Head while the Sensor is turned
ON.
The F10-S30R cannot detect red objects with white backgrounds.
Use the F10-S15R instead.
The F10-S15R cannot detect green objects with white back-
grounds. Use the F10-S30R instead.
Make sure that the length of the cable of the Amplifier is no longer
than 20 m.
Make sure that the tightening torque of each screw on the Head and
Amplifier is no greater than 1.2 N S m.
The connector on the Amplifier and the metal screws on the bottom
of the Amplifier are connected internally to 0-V terminal of the Ampli-
fier.
The operating ambient temperature range of the Amplifier is be-
tween 0°C and 50°C under the following conditions.
Others
Application Precautions
1. Provide enough ventilation to the Amplifier. If more than one
2. Do not install the Amplifier close to heat-radiating devices
3. If power lines with high current for motors are wired close to
Do not make mistakes in wiring, such as mistakes in polarity.
Doing so may cause Sensor damage or malfunction.
Do not apply voltage exceeding the rated range. Doing so may
cause Sensor damage or malfunction.
Do not short-circuit the load. Doing so may cause Sensor dam-
age or malfunction.
Organic solvents may damage the casing of the Amplifier,
which is made of ABS resin, and the transparent front panel of
the Head, which is made of acrylic resin. Do not use paint thin-
ner or any other organic solvent to clean the product.
Be sure to set the locking mechanism on the cables and units
before use.
Do not use the Sensor in an environment where the degree of
protection is not satisfied.
Do not disassemble the Sensor. Doing so may cause malfunc-
tion or breakdown.
!
Unit is installed side-by-side, provide a ventilation fan for
efficient ventilation.
such as heaters, transformers, and high-capacity resistors.
the Amplifier, make sure that the Amplifier operates normally
and take proper measures so that the power lines will not
have a bad influence on the operation of the Amplifier.
Caution
5 mm min.
Amplifiers
General Precautions
The user must operate the product according to the performance
specifications described in the brochure.
Before using the product under conditions which are not described
in the brochure or applying the product to nuclear control systems,
railroad systems, aviation systems, vehicles, combustion systems,
medical equipment, amusement machines, safety equipment, and
other systems, machines, and equipment that may have a serious
influence on lives and property if used improperly, consult your OM-
RON representative.
F10
27