ES-FL-2A BANNER ENGINEERING, ES-FL-2A Datasheet - Page 2

• Manufacturer Part Number: ES-FL-2A
• Description: 20H6269
• Manufacturer: BANNER ENGINEERING

Specifications of ES-FL-2A

• Coil Voltage Vac Nom: 24V
• Coil Voltage Vdc Nom: 24V
• Contact Current Max: 4A
• Contact Voltage Ac Nom: 250V
• Contact Voltage Dc Nom: 250V
• Contact Configuration: DPDT-NC
• No. Of Poles: 2

E-Stop Safety Relay
page
Banner Engineering Corp. has made every effort to provide complete application, installation, operation, and maintenance
instructions. In addition, any questions regarding the use or installation of Banner Emergency Stop Monitoring Safety Relay
model ES-FL-2A should be directed to the factory applications department at the telephone numbers or address shown on back
cover.
The user shall ensure that all machine operators, maintenance personnel, electricians, and supervisors are thoroughly familiar
with and understand all instructions regarding the installation, maintenance, and use of model ES-FL-2A Emergency Stop
Monitoring Safety Relay, and with the machinery it controls.
The user and any personnel involved with the installation and use of model ES-FL-2A Emergency Stop Monitoring Safety
Relay must be thoroughly familiar with all applicable ANSI/NFPA standards. The standards, listed below, directly address the
use of emergency stop systems. Banner Engineering Corp. makes no claim regarding a specific recommendation of any
organization, the accuracy or effectiveness of any information provided, or the appropriateness of the provided information
for a specific application.
The user has the responsibility to ensure that all local, state, and national laws, rules, codes, and regulations relating to the use
of this emergency stop monitoring safety relay in any particular application are satisfied. Extreme care is urged that all legal
requirements have been met and that all installation and maintenance instructions contained in this manual are followed.
U. S. Standards Applicable to Use of Emergency Stop Monitoring Safety Relays
European Standards Applicable to Use of Emergency Stop Monitoring Safety Relays
!
2
!
IMPORTANT NOTICE
ANSI B11 Standards
WARNING
device, as defined by OSHA regulations. It is necessary to install point of operation guarding devices, such as
safety light curtains and/or hard guards, to protect personnel from hazardous machinery. Failure to install point
of operation guards on hazardous machinery can result in a dangerous condition which could lead to serious
injury or death.
NFPA 79
EN292-1
EN292-2
EN60204-1
Model ES-FL-2A Emergency Stop Monitoring Safety Relay is not a point of operation guarding
Available from:
Available from:
Also, request a type “C” standard for your specific machinery.
“Standards for Construction, Care, and Use of Machine Tools”
“Electrical Standard for Industrial Machinery 1994 Edition”
“Safety of Machinery - Basic Concepts, General Principals for Design
“Safety of Machinery - Basic Concepts, General Principals for Design
“Electrical Equipment of Machines: Part 1: General Requirements”
Part 1: Basic Terminology, Methodology”
Part 2: Technical Principals and Specifications”
Safety Director
National Machine Tool Builders Association
7901 West park Drive
McLean, VA 22102-4269
Global Engineering Documents
15 Inverness Way East
Englewood, CO 80112-5704