AT32UC3A1512 Atmel Corporation, AT32UC3A1512 Datasheet - Page 87

• Manufacturer Part Number: AT32UC3A1512
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A1512

• Flash (kbytes): 512 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 69
• Ext Interrupts: 69
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 1
• Uart: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 16
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32058K AVR32-01/12
14.3
Figure 14-1. Real Time Counter module block diagram
14.4
14.4.1
14.4.2
14.4.3
14.4.4
14.5
14.5.1
14.5.1.1
Block Diagram
RC OSC
Product Dependencies
Functional Description
32 kHz
Power Management
Interrupt
Debug Operation
Clocks
RTC operation
Source clock
CLK32
RTC_CTRL
1
0
The RTC is continuously clocked, and remains operating in all sleep modes except Static. Inter-
rupts are not available in DeepStop mode.
The RTC interrupt line is connected to one of the internal sources of the interrupt controller.
Using the RTC interrupt requires the interrupt controller to be programmed first.
The RTC prescaler is frozen during debug operation, unless the OCD system keeps peripherals
running in debug operation.
The RTC can use the internal RC oscillator as clock source. This oscillator is always enabled
whenever these modules are active. Please refer to the Electrical Characteristics chapter for the
characteristic frequency of this oscillator (f
The RTC can also use the 32 KHz crystal oscillator as clock source. This oscillator must be
enabled before use. Please refer to the Power Manager chapter for details.
The RTC is enabled by writing the EN bit in the CTRL register to 1. The 16-bit prescaler will then
increment on the selected clock. The prescaler cannot be read or written, but it can be reset by
writing the PCLR strobe.
16-bit Prescaler
EN
PCLR
32-bit counter
RTC_TOP
RTC_VAL
RC
).
TOPI
AT32UC3A
IRQ
87