ATxmega128D4 Atmel Corporation, ATxmega128D4 Datasheet - Page 109

• Manufacturer Part Number: ATxmega128D4
• Manufacturer: Atmel Corporation

Specifications of ATxmega128D4

• Flash (kbytes): 128 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Speed: No
• Usb Interface: No
• Spi: 4
• Twi (i2c): 2
• Uart: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 12
• Adc Speed (ksps): 200
• Analog Comparators: 2
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 8
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 4
• Output Compare Channels: 14
• Input Capture Channels: 14
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

11.10 Clock and Event Output
11.11 Multi-configuration
8210B–AVR–04/10
Figure 11-10. Port override signals and related logic
It is possible to output both the Peripheral Clock and the signaling event from Event Channel 0
to pin. Output port pin is selected from software. If an event occur on Event Channel 0, this will
be visible on the port pin as long as the event last. Normally this is one peripheral clock cycle
only.
MPCMASK can be used to set a bit mask for the pin configuration registers. When setting bit n in
MPCMASK, PINnCTRL is added to the pin configuration mask. During the next write to any of
the port's pin configuration registers, the same value will be written to all the port's pin configura-
tion registers set by the mask. The MPCMASK register is cleared automatically after the write
operation to the pin configuration registers is finished.
PINnCTRL
D
D
D
Q
OUTn
DIRn
INn
R
R
R
R
Synchronizer
Analog Input/Output
Q
Q
Q
D
Digital Input Pin
Q
OUT Override Value
OUT Override Enable
R
DIR Override Value
DIR Override Enable
D
Pull Enable
Pull Keep
Pull Direction
Digital Input Disable (DID)
Wired AND/OR
Inverted I/O
DID Override Value
DID Override Enable
XMEGA D
Pxn
109