ATxmega32A4U Atmel Corporation, ATxmega32A4U Datasheet - Page 22

• Manufacturer Part Number: ATxmega32A4U
• Manufacturer: Atmel Corporation

Specifications of ATxmega32A4U

• Flash (kbytes): 32 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 7
• Twi (i2c): 2
• Uart: 5
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 1024
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 16
• Input Capture Channels: 16
• Pwm Channels: 16
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

4.5
4.6
8331A–AVR–07/11
Data Memory
Internal SRAM
The lock bits are used to set protection levels for the different flash sections (i.e., if read and/or
write access should be blocked). Lock bits can be written by external programmers and applica-
tion software, but only to stricter protection levels. Chip erase is the only way to erase the lock
bits. To ensure that flash contents are protected even during chip erase, the lock bits are erased
after the rest of the flash memory has been erased.
An unprogrammed fuse or lock bit will have the value one, while a programmed fuse or lock bit
will have the value zero.
Both fuses and lock bits are reprogrammable like the flash program memory.
The data memory contains the I/O memory, internal SRAM, optionally memory mapped
EEPROM, and external memory, if available. The data memory is organized as one continuous
memory section, as shown in
Figure 4-2.
I/O memory, EEPROM, and SRAM will always have the same start addresses for all XMEGA
devices. The address space for external memory will always start at the end of internal SRAM
and end at address 0xFFFFFF.
The internal SRAM always starts at hexadecimal address 0x2000. SRAM is accessed by the
CPU using the load (LD/LDS/LDD) and store (ST/STS/STD) instructions.
Data memory map.
Figure 4-2 on page
22.
Atmel AVR XMEGA AU
22