P89LPC930_931 NXP Semiconductors, P89LPC930_931 Datasheet - Page 19
![The P89LPC930/931 are single-chip microcontrollers designed for applicationsdemanding high-integration, low cost solutions over a wide range of performancerequirements](/photos/41/52/415285/sot361-1_3d_sml.gif)
P89LPC930_931
Manufacturer Part Number
P89LPC930_931
Description
The P89LPC930/931 are single-chip microcontrollers designed for applicationsdemanding high-integration, low cost solutions over a wide range of performancerequirements
Manufacturer
NXP Semiconductors
Datasheet
1.P89LPC930_931.pdf
(55 pages)
Philips Semiconductors
9397 750 14472
Product data
8.6 CPU CLock (CCLK) wake-up delay
8.7 CPU CLOCK (CCLK) modification: DIVM register
8.8 Low power select
8.9 Memory organization
The P89LPC930/931 has an internal wake-up timer that delays the clock until it
stabilizes depending to the clock source used. If the clock source is any of the three
crystal selections (low, medium and high frequencies) the delay is 992 OSCCLK
cycles plus 60 to 100 s. If the clock source is either the internal RC oscillator,
Watchdog oscillator, or external clock, the delay is 224 OSCCLK cycles plus
60 to 100 s.
The OSCCLK frequency can be divided down up to 256 times by configuring a
dividing register, DIVM, to generate CCLK. This feature makes it possible to
temporarily run the CPU at a lower rate, reducing power consumption. By dividing the
clock, the CPU can retain the ability to respond to events that would not exit Idle
mode by executing its normal program at a lower rate. This can also allow bypassing
the oscillator start-up time in cases where Power-down mode would otherwise be
used. The value of DIVM may be changed by the program at any time without
interrupting code execution.
The P89LPC930/931 is designed to run at 18 MHz (CCLK) maximum. However, if
CCLK is 8 MHz or slower, the CLKLP SFR bit (AUXR1.7) can be set to ‘1’ to lower the
power consumption further. On any reset, CLKLP is ‘0’ allowing highest performance
access. This bit can then be set in software if CCLK is running at 8 MHz or slower.
The various P89LPC930/931 memory spaces are as follows:
•
•
•
•
DATA
128 bytes of internal data memory space (00h:7Fh) accessed via direct or indirect
addressing, using instruction other than MOVX and MOVC. All or part of the Stack
may be in this area.
IDATA
Indirect Data. 256 bytes of internal data memory space (00h:FFh) accessed via
indirect addressing using instructions other than MOVX and MOVC. All or part of
the Stack may be in this area. This area includes the DATA area and the 128 bytes
immediately above it.
SFR
Special Function Registers. Selected CPU registers and peripheral control and
status registers, accessible only via direct addressing.
CODE
64 kB of Code memory space, accessed as part of program execution and via the
MOVC instruction. The P89LPC930/931 has 4 kB/ 8 kB of on-chip Code memory.
Rev. 05 — 15 December 2004
8-bit microcontrollers with two-clock 80C51 core
P89LPC930/931
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
19 of 55